olympia electronics BS-531 User manual

GENERAL
This device is a sounder for fire detection
panels that offer a strong sound and an
optical warning with a beacon that covers
many square metres. The main tone
frequency is 2.5kHz (±20%).
This device can co-operate with any fire
detection panel (BSR-2104, BSR-2114,
BS-1632, BS-1634, BS-1636, BS-636).
Installation and Connection
1. First, remove the retaining screw, place
a flat blade screwdriver in the holes of the
plastic hooks and remove the plastic cover
(Image 1 on page 2).
2. Use the supplied mounting parts to install
the siren’s base on the wall. Place the
plastic plugs and fasten the screws to the
mounting holes.
3. Place the caps and make a hole in the
center using a small screwdriver. Pass
through the caps the cables to connect the
device.
4. The (+) of the terminal block is
connected to the (+) output of Alarm-1 or
Alarm-2 of the panel and the (-) of the
terminal block is connected to the (-) output
o f A l a r m - 1 o r A l a r m - 2 o f t h e
panel.Accordingly connect in parallel all the
sirens. (The maximum number of sirens
depends on the type of the panel).
5. On the last siren of the line, we must
connect in parallel with its power cables,
the terminal resistor that was removed
from the alarm contacts of the panel.
6. Refit the plastic cover until the plastic
hooks are securely attached (step 1) and
fasten the retaining screw (torque
0.6Nm).
7. Test the device after installation.
Certification
The electronic fire alarm sounder BS-
531 is certified from EVPU. Also
EVPU controls the production under
CPD number:
921531000_09_013
Page 1 from 2
Thank you for your trust in our products.
Olympia Electronics - European manufacturer.
ΒS-531
SOUNDER WITH BEACON FOR FIRE DETECTION PANEL
21-28V DC
40mA
OPERATION VOLTAGE
MAXIMUM CONSUMPTION
MAXIMUM SOUND OUTPUT in1m
ΤYPE OF APPLICATION ENVIRONMENT
MOUNTING
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
CONSTRUCTION MATERIAL
TECHNICAL CHARACTERISTICS
IP42
EN 54-3: 2014
0 to 60 C
o
Up to 95%
200gr.
141 x 141 x 95 mm
2 years
Bayblend FR3010, transparent polycarbonate
Τype A
Wall
88dB
BEACON 4 red LEDs
BS-531 Siren with beacon for
fire detection panel 1293
1293-CPD-0356 12
EN-54-3
P C 300 P.O. Box 06 Eginio Pierias Greece. . 60

921531000_09_013
Page 2 from 2
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72nd km. Ο.N.R. Thessaloniki-Κaterini
P C 300 P.O. Box 06 Eginio Pierias Greece. . 60
www.olympia-electronics.gr
[email protected]
Image 1
1
11
Image 2
2
2
TO FIRE
DETECTION
PANEL
+
5
2
4 4
N O T E ! ! ! A ft er f i n i s h i n g th e
installation, place the SEAL sticker
as shown in the picture.