Open Plan Systems EMERGE II User manual

EMERGE II ASSEMBLY GUIDE
1. Attach the Baseplate
Flip over the main part of
your Emerge II unit to attach
the baseplate to the bottom.
Use 8 screws to secure the
baseplate.
2. Build the Arm
Flip the provided work
surface upside down then
attach the arm to the work
surface. This will use 5 screws.
3. Attach the Arm
Slide the arm over the top of
the main unit. There will be
four holes at the bottom of
the main unit that align with
the arm to attach it.
www.openplan.com | 844.OPS.OPS1 | [email protected]
4. Secure the Top Plate
Single Monitor Unit - Mount
the top plate and monitor
to the provided VESA mount,
then skip to step 8.
Multiple Monitor Units - If you
are using a multiple monitor
system, attach the top plate,
then secure the monitor
arm pole to the plate. Once
complete continue to step 5.
1
2
3
4
Single Mount Multi Mount

EMERGE II ASSEMBLY GUIDE
5. Multiple Monitor Mount
If you are mounting multiple
monitors. You will continue by
attaching the Mounting Pole
to the top plate from step 4.
6. Slide on and Secure Arm
Once the Mounting Pole
is secure, slide on the Arm
System from below, then
install the safety screw.
7. Secure VESA Monitors
Attach the VESA Mounts to
your monitors, then slide
them overtop the mounts on
the arm system. Secure each
monitor with a screw cap.
www.openplan.com | 844.OPS.OPS1 | [email protected]
8. Power up your Emerge II
Plug in your Emerge II unit
and press the buttons on the
provided remote to ensure
everything is working properly.
5
6
7
8