Orion VALUE SERIES User manual

Installation and User’s Guide
http://www.orionimages.com
All contents of this document may change without prior notice, and actual product appearance may differ
from that depicted herein
Installation and User’s Guide
17” & 19” TFT-LCD MONITOR
(SECURITY)
VALUE SERIES LCD MONITOR

2
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg2
* Follow this safety instruction to use the monitor properly and prevent the damages.
* Keep this user’s guide book for later use.
Warning Statements
* This safety instruction has “ Warning” and “ Caution” as below.
WARNING: If the user does not follow this instruction,
it may cause the serious damage to the user.
CAUTION: If the user does not follow this instruction, it may cause the slight
damage to the user or cause some damages to the monitor.
Never remove the back over and touch
the inside of the monitor. If you need a
service, please contact the service center.
Keep away the monitor from the
direct sunlight and a heating appliance.
Never push objects of any kind into this
product as they may result in a risk of fire
or electric shock.
Connect the power code to the wall
outlet tightly. If the power code or plug are
defective and the wall outlet is not tight,
p
lease do not use them.

3
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg3
Warning Statements
Do not install this monitor on the outside
and near water. If may cause damage to
the product, electric shock and fire.
For cleaning do not use liquid cleaners.
Never touch the power plug with wet-
hands.
When lightning and thundering, unplug
the monitor from the wall outlet and never
touch it.
Unplug this product from the wall outlet,
when It does not operate for a long time.
When smoking and noising from the
monitor, unplug the product from the wall
outlet and contact a service center.
How to fix
1. Do not open this product as it contains high voltage inside.
2. It may create an electric shock.
3. It the user disassembles and remove the back cover, it does not make sure
4. To make up for the damages and do a service and exchange the monitor..

4
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg4
Cautions
Install this monitor some distance
From the wall and do not install unless
Proper ventilation is provided.
Place this product on a stable place.
If not, it may fall, causing serious
Damages to the monitor and people.
The openings must not be blocked by
curtain, rug or other similar surface. When carrying this monitor, be careful
not to damage the panel and drop it
It may cause some trouble.
Before carrying the monitor, tum it off
and Unplug the signal cables and the
power code From the wall outlet.
Take the power plug out from the wall
outlet. Do not pull the cable. It may
snap the inner wires and cause
overheating and fire.
Install this monitor about 50cm far from
the eyes and an angle of 0~15 degrees
below eyes. Too close installation may
cause having weak sight.
Do not press the LCD panel with hands
or the sharpened material hardly.
For cleaning, unplug the monitor from
the Wall outlet. Do net use the liquid
cloth. Use the soft cloth.
Do not use the chemical liquid for
cleaning. It may cause fading and
breakage.

5
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg5
TABLE OF CONTENTS
1. INSTALLATION .................................................................................................................
1.1 Parts ……....................................................................................................................
2. FEATURES …..................................................................................................................
2.1 Specifications …….……..............................................................................................
3. OSD SETTING .........................................................................................................
7. TROUBLESHOOTING
..
....
.
................................
.......................
.................
....................
8. LIMITED LIFETIME WARRANTY
..
....
.
.......................................................
.................
...
4. CONTROL BUTTON
..
....
.
.......................................................
................
...................
......
1.2 How to Install …….........................................................................................................
6. INFORMATION TO THE USER
..
....
.
.......................................................
................
.........
5. APPENDIX
..
....
.
.......................................................
................
.........................
1.3 Remote Controller ....................................................................................................
6
6
9
9
10-13
17
18
14
7
16
15
8

6
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg6
INSTALLATION
1.1 P
a
r
ts
Remove the package cover and place the product on a flat and secure surface or in the
installation location. Check whether all the following device and accessories are included with
the main system.

7
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg7
INSTALLATION
1. DC 12V IN
2. RGB IN
3. S-VIDEO (Y/C) IN
4. S-VIDEO (Y/C) OUT
5. VIDEO2 (AV2) IN
6. VIDEO2 (AV2) OUT
7. VIDEO1 (AV1) IN
8. VIDEO1 (AV1) OUT
9. AUDIO2 IN
10. AUDIO1 IN
11. PC STEREO IN
RGB signal input
Y/C separated signal input
Y/C separated signal looping output
Composite signal input for VIDEO2
Video looping output for VIDEO2
Composite signal input for VIDEO1
Video looping output for VIDEO1
Stereo audio signal input. This output is for AV2
Stereo audio signal input. This input is for AV1, S-VIDEO
1.2 Connection

8
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg8
INSTALLATION
1.3 Remote Controller
1. POWER
2. MUTE
3. VIDEO1
4. VIDEO2
5. S-VIDEO
6. RGB
7. AUTO
8. COLOR TEMP
9. VOL-/VOL+ (◀▶)
10. UP/DOWN(▲▼)
11. MENU / EXIT
12. KEY LOCK
Turns the power ON or OFF. There will be a few
seconds delay before the display appears.
Mute the sound.
Select Video1 source.
Select Video2 source.
Select S-Video source.
Select RGB source.
Auto geometry adjustment in RGB source.
Select color temperature.
Increases or decreases the level of audio volume.
Move to OSD menu.
Activates and exits the On Screen Display.
Prevents unauthorized operation of the equipment by locking the
buttons. Key Lock feature by pressing and holding the ▲ and ◀
buttons for five seconds.

9
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg9
FEATURES
VIDEO
Screen Size 17” 19”
Viewing Area 338.0 x 278.0mm 376.0 x 301.0mm
Pixel Type Active Matrix TFT
Max. Resolution 1280 x 1024 @ 60Hz (SXGA)
Pixel Pitch 0.264 x 0.264mm 0.294 x 0.294mm
Brightness 250 cd/㎡
Contrast Ratio 800 : 1
Aspect Ratio :4:3
Viewing Angle (H/V) 160 / 160
Display Color 16.7Million
Response Time < 5ms
Video System NTSC / PAL / SECAM
Frequency (H) 31 ~ 48KHz
Frequency (V) 55 ~ 75Hz
Panel Lamp Life 50,000hours
MECHANICAL
Packing Dimension
W x H x D 20.0” x 16.1” x 6.5” 20.0” x 16.1” x 6.5”
Weight 17.6lbs 19.4lbs
Power Consumption 40W 45W
DC12V adapter (Auto Switching) / 3.4A (17 inch)
Power Source DC12V adapter (Auto Switching) / 3.8A (19 inch)
2.1 Specification (17 & 19 INCH)

10
Installation and User’s Guide
htt
p
://www.orionima
g
es.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: [phone] / Fax: [phone] pg10
OSD (On Screen Display) SETTING
A. Input Select
B. Picture Menu
1. Press the SOURCE button and then ▲/▼ button to move
the source.
2. Press the ▶ button to select the source.
3. Press the MENU/EXIT button to exit the INPUT menu.
3.1 OSD MENU Description
MENU SELECTION
1. Press the MENU key to access the Main menu.
2. Use the and arrow key to highlight a selection
3. Press the OK or button to select an item.
4. Use the and arrow key to highlight a selection.
5. Use the and arrow key to adjust the setting on a selected item.
Inputs can be set to VIDEO1, VIDEO2, S-VIDEO and RGB mode.