Orion ARXS1 User manual

LED AREA LIGHTER INSTALLATION INSTRUCTIONS
PRODUCT SERIES: ARXS1
Ambient temperature for lighting fixture: -30℃~50℃
Safety Instruction
¾Read instructions carefully before attempting to install fixture. Retain instruction for future reference.
¾All wiring should be performed by a qualified electrician.
¾Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical
Code and applicable local codes and ordinances.
¾Proper grounding is required to ensure personal safety.
¾This fixture is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.
¾Caution – Risk of Fire
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts
inside.
Location
Fixture should be located at least 18” below any overhang or other structural detail.
Fixture should not be recessed.
Installation
This flood light is supplied with trunnion mounting This flood light is also available with anadjustable
bracket for surface mounting, make sure fixture is Slip Fitter.
securely mounted.
Trunnion: Slip Fitter
The trunnion mounting bracket offers five 1. Assemble slip fitter and gasket to Housing using
different positions. There are three position hardware provided
holes in the outer yoke and five positioning 2. Assemble lower fitter onto the upper fitter after
holes in the inner yoke. To make a selection, removing splice compartment cover.
remove the positioning screw, loosen trunnion 3.Slip lower fitter over tenon and securely tighten
bolts, rotate trunnion to desired angle. Reinsert two allen head set screws. The lower fitter is
positioning screw and tighten. designed to slip over 2-3/8’’ o.d. heavy wall pipe
or tenon

Arm Mounted:
1. Take the arm from the package. Take apart the arm.
2. Open the frame and take the LED module from the fixture. Be careful with the LED module, Keep them in the safety and cleanly.
3. Each Rod with a M10 nuts. Let the rod go through the Mounting Plate B ,GasketA, Fixture, & Mounting plateA. Rotate the nuts, and let the rods
securely on the fixture
4．Secure the LED module & frame on the fixture.
5．Put the arm, Gasket B &Arm Base on the rods.
6. Mounted the whole fixture to the Pole (Showed in the below)
7. Put the flat washers, spring washers and the M10 nuts on the rods. Rotate the nuts to securely the fixture on the pole.
(If the arm was assembled on the fixture, then you can take step 6 & 7 only).
Wiring
Universal voltage driver permits operation at 100V to 277VAC, 50 or 60Hz except fixtures factory ordered with a 120V photocell (/PC).
1. Connect the black fixture lead to the (L) LINE supply lead.
2. Connect the white fixture lead to the (N) COMMON supply lead.
3. Connect the bare copper Ground wire from fixture to supply lead.
Cleaning & Maintenance
Caution: Be Sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is energized
1. Clean glass lens with non-abrasive glass cleaning solution
2. Do not open fixture to clean the LED. Do not touch the LED.
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation,
operation or maintenance.
Gasket B
Arm
M10 Nuts
Gasket A
Housing
Frame
LED module
Mounting
Plate A
Cable Gland
Mounting
Plate B
M10 Rod
Arm Base
Flat Washe
r
Spring Washer
M10 Nuts
Pole Cap
Pole
ARXS1-060L ARXS1-090L