Oster 3157 User manual

Instruction Manual
JUICE EXTRACTOR
PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
Manuel d'Instructions
CENTRIFUGEUSE À JUS
LIRE TOUTES LES INSTRUCTIONS AVANT D'UTILIZER CET APPAREIL
Manual de Instrucciones
EXTRACTOR DE JUGOS
LEA TODAS LAS INSTRUCCIONES ANTES DE USAR ESTE APARATO
Manual de Instruções
CENTRIFUGA
LEIA TODAS AS INSTRUÇÕES ANTES DE USAR ESTE APARELHO
3157
3157

1
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed
including the following:
• Read all instructions before using your juice extractor
• To protect against risk of electrical shock, DO NOT put power cord or motor base in water
or any other liquid
• Close supervision is necessary when any appliance is used by or near children
• Unplug from outlet when not in use, before putting on or taking off parts, and before
cleaning
• Avoid contact moving parts. DO NOT touch the small cutting blades located at the base of
the stainless steel filter
• DO NOT operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest
authorized service center for examination, repair or electrical or mechanical adjustment
• The use of attachments not recommended or sold by the manufacturer may cause fire,
electric shock or injury
• DO NOT use outdoors
• DO NOT let cord hang over edge of table or counter
• DO NOT let cord touch hot surfaces, including the stove
• DO NOT operate this appliance continuously for more than 5 minutes
• Always make sure juicer lid/cover is clamped securely in place before motor is turned on.
DO NOT unfasten clamps while juicer is in operation
• Be sure to turn switch to off position “O” after each use of your juicer. Make sure the
motor stops completely before disassembling
• DO NOT PUT YOUR FINGERS OR OTHER OBJECTS INTO THE JUICER OPENING
WHILE IT IS IN OPERATION. IF FOOD BECOMES LODGED IN THE OPENING, USE
FOOD PUSHER OR ANOTHER PIECE OF FRUIT OR VEGETABLE TO PUSH IT
DOWN. WHEN THIS METHOD IS NOT POSSIBLE TURN THE MOTOR OFF AND
DISASSEMBLE JUICER TO REMOVE THE REMAINING FOOD
• DO NOT use the appliance if the rotating sieve/filter is damaged
• DO NOT push produce into the feed chute with your finger. Always use the food pusher
provided
• DO NOT touch the small cutting blades in the base of the stainless steel filter basket
• Always make sure the juice extractor is properly and completely assembled before
operating. The unit will not turn on unless properly assembled
• Always use the juice extractor on a dry, level surface
• Always turn the juice extractor off first before unplugging it from the outlet

2
SAVE THESE INSTRUCTIONS
(For 120 & 127 Volts Only)
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is
wider than the other). This plug fits a polarized outlet only one way. This is a safety
feature intended to help reduce the risk of electrical shock. If the plug does not fit fully
into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do
not attempt to defeat this safety feature.
If a longer detachable power-supply cord or extension cord is used, the marked
electrical rating of the extension cord should be the same as that of your juicer. The
extension cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on by children or tripped over unintentionally.
• DO NOT place this appliance on or near a hot gas or electric burner or where it could
touch a heated oven
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY.

3
DESCRIPTION OF THE APPLIANCE
1. Powerful 400-watt Motor
2. Safety Locking Arms (both sides)
3. Food Chute
4. Stainless Steel Filter
5. Filter Basket
6. Large Capacity 600 mL (2.5-cup) Jar
7. Large Pulp Collector Container
8. ON/OFF Switch (I/O)
9. Food Pusher
10. Juice Extractor Lid/Cover
11. Motor Base Housing
12. Safety Switch (both sides)
4
2
8
11
7
16
9
10
5
12
3

4
INSTRUCTIONS FOR USE
BEFORE USING YOUR JUICE EXTRACTOR
Follow the assembling instructions listed below before using your Oster® Juice
Extractor:
• Before you start assembling your juice extractor, make
sure it is unplugged and it is placed on a dry and
level surface
• Place filter basket on top of the motor base (Figure 1)
• Place the stainless steel filter on top of the filter basket
pushing down and turning it until it fits into the grooves of
the motor shaft (Figure 2)
• Place juicer cover/lid on top of the filter basket (Figure 3)
• Raise the safety locking arms, then lower them to
securely fit into the grooves in the lid and then firmly
press lower part of the locking arms into the unit ensuring
they lock the lid into the unit (Figure 4)
• Place the pulp container into position by tilting it slightly
(Figure 5)
Important: Make sure Pulp Container edge is
underneath basket
• Place the 600 mL jar under the spout located on the right
hand side of the juicer by tiltin g it slightly. Other jars or
glasses can be used as well (Figure 6)
Figure 1
Figure 2
Figure 3 Figure 5
Figure 6
Figure 4

OPERATING INSTRUCTIONS
1. Prepare your fruits and vegetables by washing them thoroughly and peeling off
those that need the skin removed.
2. Prepare the fruits and vegetables by cutting them into smaller pieces to ensure they
will fit in the chute.
3. Make sure your juice extractor is properly assembled. Please follow the instructions
from the section “Before Using Your Juice Extractor.”
4. Ensure the juice extractor and its accessories are clean by following the cleaning
and maintenance section of this manual.
5. Place the jar or any other container/glass you may wish to use to collect the juice
under the spout and make sure the pulp collector is in place prior to begin juicing.
Do not allow the pulp collector container to overfill as this may cause the unit to stall.
6. Plug the power cord into an electrical outlet and turn the unit on “I.”
7. Once the juicer is on, place the fruits and vegetables on the food chute and use the
food pusher slowly to drive them down. In order to extract the maximum amount of
juice, it is important to push the food pusher slowly.
8. The juice extractor will separate the juice and the pulp in the jar and pulp collector
while you are juicing.
NOTE: Both the pulp container as well as the jar can be emptied during juicing by
turning the juice extractor off “O.” Make sure to place both containers back in
place before you resume juicing.
NEVER USE HAND OR FINGERS TO PUSH FOOD DOWN THE FOOD CHUTE OR
TO CLEAR THE FOOD CHUTE. ALWAYS USE THE FOOD PUSHER PROVIDED.
5

6
AFTER USING YOUR JUICE EXTRACTOR
Before cleaning and storing your juice extractor, follow the instructions below to
disassemble the unit:
• Turn juice extractor off “O” and unplug it
from the electrical outlet (Figure 1)
• Remove the jar and the pulp collector
container by tilting it slightly (Figure 2)
• Unlock the safety locking arms to release
the cover/lid (Figure 3)
• Lift the lid up and remove it from the juice
extractor (Figure 4)
• In order to remove the filter basket and the
filter, hold the filter basket with two hands
and then lift it straight up (Figure 5)
WARNING: THE STAINLESS STEEL FILTER BASKET CONTAINS SMALL SHARP BLADES
TO CUT AND PROCESS FRUITS AND VEGETABLES. DO NOT TOUCH BLADES WHEN
HANDLING THE FILTER BASKET.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5

CLEANING
• After disassembling all removable parts of the juice extractor, wash them by hand
with warm soapy water or in the dishwasher (top shelf only). If the pulp dries out in
the pulp collector container, the filter or the filter basket, let it soak in water for
approximately 10 minutes before washing it
• Wipe the motor base with a damp cloth
• It is very important to keep the filter very clean, free of residues blocking the holes in
order to ensure optimal performance. Use a nylon brush to clean it thoroughly, if
necessary. If the holes in the mesh remain blocked, soak the filter in hot water with a
water solution with 10% lemon juice
NOTE: DO NOT IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER LIQUID.
MAINTENANCE
• Some plastic parts might stain when in contact with some fruits and vegetables for
too long. In order to avoid this from happening, all parts should be washed
immediately after each use
7

PROBLEMS AND SOLUTIONS
PROBLEM SOLUTION
• Safety locking arms may not be locked properly
in its position
• Turn off and unplug unit and ensure all parts are
assembled properly
• Turn off and unplug unit and check if there are any
residues blocking the unit
• Turn off and unplug unit and ensure all parts are
assembled properly
• Juicing overripe fruits may produce too much pulp
and clog the filter. Turn off and unplug unit and
clean the filter thoroughly
• If pulp starts building up under the lid, slow down
the juicing process. Turn off and unplug unit and
clean the filter basket, the stainless steel filter and
the lid
• Follow the instructions to disassemble the unit
included in the “After Using Your Juice Extractor”
section. Clean up pulp from the filter
• Try a slower juicing action. Remove stainless steel
mesh filter and thoroughly clean mesh with a nylon
brush. Rinse the filter basket with hot water. If the
fine mesh holes are blocked, soak the basket in a
solution of hot water with 10% lemon juice to
unblock the holes or wash in the dishwasher. This
will remove excess fiber build up (from fruit or
vegetables), which could be reducing the flow of
juice
• Try a slower juicing action by pushing the Food
Pusher down slower
Juice Extractor will not work
after switching on “I”
Motor makes loud noise and
unit starts vibrating
Motor appears to stall when
juicing
Too much pulp build up on
stainless steel filter
Pulp too wet and reduced
juice extraction
Juice leaks between the rim
of the Juicer and Cover
the Filter.
8

9
TIPS AND SUGGESTIONS
• Do not place any fruits or vegetables until you turn the unit on. Allow unit to run for at
least 10 seconds before you start juicing
• Do not allow the pulp container to overfill as this may prevent correct operation or
damage the unit
• Ensure to remove large pits from fruits such as peach, mango, etc as they can
damage the unit
• You can use a plastic bag inside the pulp collector container to avoid having to
clean it
• Do not use bananas or avocados as they do not contain juice and will clog the unit.
You can use a blender to add them to the juice
• You can use the pulp of the juices you prepare in a variety of ways. The pulp from
fruits and vegetables contains high amounts of fiber and cellulose, which are
essential for a healthy and well balanced diet. You can use the pulp to thicken soups,
bulk up rissoles and thicken casseroles or to enhance your desserts. Make sure to
use the pulp the same day you juice to avoid loss vitamins