Outsunny 84C-251 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
READ AND SAVE THIS INSTRUCTIONS FOR FUTURE USE
INbra002_US
84C-251

Warning: .
1. A 3 person assembly is required for this tent.
2. Please take appropriate actions as heavy rain, wind and snow
can damage the tent. If necessary please dis-assemble and store
for later use.
3. In snowy conditions please do not alow the thickness of the
snow to be more than 5cm on the roof, this should be cleared as
soon as possible for your safety.

PART
LIST
1. With two persons on the diagonal ends, lift and partially pull the canopy frame apart.
① 1 ② 1
③ 1 ④16 ⑤ 4
01

3. Under the canopy, place one hand on the upper frame and use the other hand to push the
central hub straight up until it clicks into the central pole. Finish attaching the large canopy
inside the canopy frame using the Velcro loops.
2. Unfold the large canopy top and place it over the open frame. Attach the four canopy
corners to the top corner of leg tube .
03
02

5. Attach the ropes to the plastic rings on the awning and tie the ropes to the stakes in the
ground.Ensure the ropes have the proper tension by adjusting the plastic adjusters on the
ropes.
4. Press the red button on each leg and raise or lower to adjust the canopy height.
05
04

1. Release the ropes from the plastic rings.Pull up all stakes from the ground.
01
Done
After Each Use

3. Get in the underneath of canopy, rotate counterclockwise the central bottom hub to unlock
the frame.
2. Press the red button on each leg and retract the legs to their original height.
03
02

5. With the canopy feet facing the rollers, slide the wheeled storage bag over the closed
canopy frame.Close the zipper on the wheeled storage bag.
4. Lift one corner of the frame until all legs are raised off the ground except for the 1 leg on
the opposite corner. Push inward until the frame is fully closed.
04
Done