Outsunny 84C-249 User manual

ASSEMBLY & INSTRUCTION MANUAL
READ AND SAVE THIS INSTRUCTIONS FOR FUTURE USE
INbra001_US
84C-249

Warning: .
1. A 3 person assembly is required for this tent.
2. Please take appropriate actions as heavy rain, wind and snow
can damage the tent. If necessary please dis-assemble and store
for later use.
3. In snowy conditions please do not alow the thickness of the
snow to be more than 5cm on the roof, this should be cleared as
soon as possible for your safety.

PART
LIST
1. Need 4 persons to assemble the canopy. Stand frame upright. Starting at the corners,
with a partner standing on the opposite side, grasp the two out legs, slightly lift the frame off
the ground and step backward, stopping at full arms' length.
① 1 ② 1
③ 1 ④16 ⑤ 4
01

3. Each person should then grasp the bottom of the middle frame section(cross beams)
where it forms a diamond. Lift slightly and slowly walk backward until the frame is fully
extended. Be careful not topinch your finger or pull backward too hard as this may result in
the bending of cross beams.
2. Place the Main Canopy over the top frame. Use the Velcro pads to secure each corner of
the canopy to the frame under the plastic leg caps.
03
02

5. Lift two adjacent outer legs and pull out inner legs gently until spring loaded snap button
pops in position. Repeat on the other two legs. The gazebo offers twoheight levels. To
adjust, lift the leg up,carefully depress the push button at knuckle and slowly pull out the
inner leg until the snap button pops in next position. Repeat on the other legs. Be careful do
not overpull the leg and exceed maximum height.
4. Engage the slider at each corner by pushing up the slider with one hand while holding
down the top of the leg with the other hand. Repeat this at the rest of corners.
05
04

7. Secure the gazebo by driving a stake down through one of the holes in each foot base.
6. Attach the Velcro straps around the frame to secure canopy top.
07
06

1. Put up all stakes from ground.
8. Measure out from the leg to a proper distance and secure the four big stakesto ground at a
45 degree angle. Tie up one end of each guide rope to the triangular shaped rope holder
located on the outside fabric cormers. Tie the other end of each rope to the stake on the
ground. Make sure the guide ropes have the proper tension.
08
After Each Use
Done
01
Disassembling the Gazebo
Store all parts (like the stakes) in the corresponding bag to prevent possible tearing or
damage to the fabric.

3. Release each push pin on MIDDLE leg and shorten the frame to its original height prior to
extending the legs during set-up.
2. Detach Velcro Straps from each side of the canopy frame.
03
02

5. With partner on the opposite side, grasp the middle section of the frame and lift up slightly.
4. Release each konb button on each Corner leg and shorten the frame to its original height
prior to extending the legs during set-up.
05
04

7. Completely close the frame with or without the canopy attached.
6. Walk forward slowly allowing for the frame to fold inward and close. Be careful not to pinch
fingers or hands as you close the frame.
07
06