PAC PAC-200 Service manual

The relay will handle 200 amperes on a continuous basis at 12 VDC and 300 Amperes in rush peak or surge.
Mount the relay between batteries as an isolator or in the main power lead servicing the mobile audio system,
amplifiers, light bars or any other equipment requiring on/off control.
INSTALLATION INSTRUCTIONS:
The two small terminals are for switching the relay on and off. Either one of the small terminals should be
connected to chassis ground or other ground location and the other terminal to switching power output. Switching
power must be between 10 and 16 VDC. The relay coil draws less than 1amp when switched on.
Battery or main power leads use the two large terminals. Either one may be incoming power. Fuse power leads as
close to battery or batteries as possible.
MODEL PAC-200
MOBILE AUDIO RELAY AND BATTERY ISOLATOR
200 Amp Continuous Power Handling
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
www.go2pac.com Voice: 714-835-3133 Fax: [phone] [email protected]
_+
Battery
_+
Battery
FUSE
FUSE
PAC-200
Alternator
+
Accessory