Panasonic F-PXF35X User manual

Please disconnect power plug and contact to the dealer for repairs.
17
18
Specifications/Other accessories
17
18
.......................................
.....................................
...........................................
....................................................
............................................
............................................
................................
...................................
...........................................
..........................................
..................
Thank you very much for purchasing this Panasonic product.
Please read these operating instructions carefully in order to use the product correctly and in a safe manner.
Also,be sure to read the “Safety precautions” section (page 4-5) before use.
Make sure that the correct information is written on the warranty card,including the date of purchase and
the name of the distributor.
Keep the warranty documentation in a safe place along with the operating instructions for future reference.

Back
Front
Parts indentification
Further information
Control panel(P.10)
Clean sign(P.10)
Front panel
Air inlet
(both sides)
Air inlet
(front)
Dirt sensor
Handle
(left and right)
Power cord
Power plug
操作面板(见第10页)
清洁指示(见第10页)

All air volume indicator
are flickering
Symptom Check point/Solution
Safety precautions Troubleshooting

FAQs

To prevent the air inlet or the air outlet
from being blocked,install the equipment
with its left,right and the top about 30 cm
or more away from walls or furniture,
curtains etc.To ensure efficient use of this
unit,keep its back at least 5 cm away from
the wall.
Children should be supervised to ensure that they do not play with the unit.

Do not wipe it with a hard
clothor too much force.
Otherwise,the surface may
be damaged.
(Installation and removal
methods of the front
panel P.6)
Please dispose of the used filter as non-flammable
rubbish.
Care and maintenance
Main unit and front panel
< Once a month or so >
Composite air filter
< Once a fortnight or so >
General timetable for filter replacement

Do not operate the unit when the composite air
filter is removed.Dust will be inhaled into unit inner
parts,and causes the unit breakdown.The composite
air filer can not function while it is removed.
Do not operate the unit when the deodorizing filter
is removed.The deodorizing filter can not function
while it is removed.
When cleaning, do not leave the removed parts
unattended.(parts left unattended may be cause
of tripping or they may be damaged.)
Preparation
Care and maintenance

(Air Volume indicator lights up)
When using for the first time or inserting
the power plug again,operation will begin
with the Air Volume under ‘Auto’.(The
clean sign will flash in blue or red for about
five senconds and auto operation will
begin.)
Other than the above situations,operation
will begin with the air volume from the last
time it was stopped.
When the dirt sensro is in a state of
preparation,the ‘Auto’ indicator will flash
regardless of the operationmode.
(When the power plug is removed and
re-inserted,the indicator blinks as well.)
(Air volume indicator will be switched off)
(It will switch every time it is pressed.)
The level of the dirt in the air will be detected
by the dirt sensor and the air volume will switch
automatically.
The dirt in the air is removed quickly with the
maximum air volume.
Operation with air volume between Hiigh and
Low.
Quite operation with the minimun air volume
(the speed of removal of dirt in the air will
slow down)
Operating methods

When this button is pressed,the clean sign will be
switched off and weak operationa mode will begin.
After eight hours,the sleep operation will edn.(sleep
indicator is off)
When you want to deactivate it.
Press the button again.(The indicator turns off.)
Control panel
Press this button to begin ‘turbo’ operation.During
speed timing operation, the clean sign will flash in
blue or red.After 10 minutes,the turbo operation
ends and will return to the previous operation mode.
When you want to deactivate it.
Press the button again.(The indicator turns off.)
Operating methods