Panasonic ET-RFF100 Guide

Replacement Instructions
ARF unit for LCD Projector
R
ET-RFF100Model No.
TQZH907-5
These symbols on the products, packaging, and/or accompanying
documents mean that used electrical and electronic products and
batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used
batteries, please take them to applicable collection points, in accordance
with your national legislation and the Directives 2002/96/EC and
2006/66/EC.
By disposing of these products and batteries correctly, you will help to
save valuable resources and prevent any potential negative effects on
human health and the environment which could otherwise arise from
inappropriate waste handling.
For more information about collection and recycling of old products and
batteries, please contact your local municipality, your waste disposal
service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in
accordance with national legislation.
Information for Users on Collection and Disposal of Old Equipment and
used Batteries
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact
your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European
Union]
These symbols are only valid in the European Union. If you wish to
discard these items, please contact your local authorities or dealer and
ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol.In this
case it complies with the requirement set by the Directive for the
chemical involved.
Read these instructions completely before replacement.

ARF
PUSH 押す
Replacing the ARF
Replacement procedure
2-ENGLISH
●
●
●
●
Soft cloth
ARF cover
ARF cover fixing screw
ARF fixing screw
Before replacing the ARF
䎃
Press the POWER button for at least 0.5 seconds or press the POWER
button twice to turn off the projector.
Wait until the cooling fan stops and the POWER indicator turn to RED.
Disconnect the mains plug from the mains socket.
Prepare a Phillips-head screw driver.
1.Turn the projector upside down and place it gently on a soft cloth.
2. Use a Phillips-head screwdriver to loosen 3 ARF cover fixing screws until
the screws turn freely and remove the ARF cover.
3. Use a Phillips-head screwdriver to loosen an ARF fixing screws and
release the clamp, then slightly slide up the used ARF to remove.
* When you replace the ARF unit, clean the compartment and/or the Air
exaust port if you need to.
Clamp
Grip

ENGLISH-3
4. Insert the new ARF into the compartment in correct direction and slightly
push down until it clicks. Tighten the ARF fixing screws securely with a
Phillips-head screwdriver.
5. Attach the ARF cover and tighten the ARF cover fixing screws securely
with a Phillips-head screwdriver.
6. Turn on the projector and display the FILTER REMAINING in OPTION
menu. Press the ENTER button for 3 seconds and the confirmation screen
will be displayed.
7. Press Ito select OK and press the ENTER button to reset the FILTER
REMAINING to "0".

Printed in Japan
https://panasonic.net/cns/projector/