8
Getting Started
First-time Operation
3 Setup Windows.
Follow the on-screen instructions.
l The computer restarts several times. Do not touch the
screen or tablet buttons, and wait until the drive indicator
has turned off.
l After the computer is turned on, the screen remains black
or unchanged for a while, but this is not a malfunction.
Wait for a moment until the Windows setup screen ap-
pears.
l Setup of Windows will take approximately 5 minutes.
Go to the next step, conrming each message on the display.
l You can set the Wireless Network after the setup of Win-
dows is complete.
If “Get online” is displayed, you can select “Skip this
step”.
CAUTION
l
You can change the user name, password, image and secu-
rity setting after setup of Windows.
l
Remember your password. If you forget the password, you
cannot use Windows. Creating a password reset disk before-
hand is recommended.
l
Do not use the following words for user name: CON, PRN,
AUX, CLOCK$, NUL, COM1 to COM9, LPT1 to LPT9, LPT,
@, &, space. In particular, if you create a user name (account
name) that includes the “@” mark, a password will be re-
quested at the log-on screen, even if no password has been
set. If you try to log on without entering a password, “The
user name or password is incorrect.” may be displayed and
you will not be able to sign in to Windows (èpage 24).
4 Create the recovery disc.
A recovery disc allows you to install OS and restore its factory
default condition, in case, for example, the recovery partition
of the ash memory is damaged. We recommend creating a
recovery disc before you begin using the computer.
Refer to èOperating Instructions - Reference Manual
“Recovery Disc Creation Utility” about creating the disc.
NOTE
l PC Information Viewer
This computer periodically records the management information of the ash memory, etc. The
maximum data volume for each record is 1024 bytes.
This information is only used for estimating the cause when the ash memory goes down by
any possibility. They are never sent to outside via network nor used for any other purpose
except for the purpose described the above.
To disable the function, add the check mark for [Disable the automatic save function for man-
agement information history] in [Hard Disk Status] of PC Information Viewer, and touch [OK].
Then follow the on-screen instructions.
(
èOperating Instructions - Reference Manual “Checking the Computer’s Usage Status”)
