Panduit PanZone PZICGK User manual

FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
INSTRUCTIONS CM378
© Panduit Corp. 2008
1.1. Install bonding studs through the inside of the enclosure door until nuts contact the door surface. See Figure 1.1.
1.2. Install bonding nuts to studs on the outside of the door to hold in place. See Figure 1.2.
Page 1 of 2
PANZONE In-Ceiling Grounding Kit
Part Numbers: PZICGK
Required Components
#12 External
Tooth
Installation: Bonding Studs
(2) Equipment Jumpers
(3) #12-24 Hex Washer
Head
Figure 1.2
Figure 1.1
Enclosure
Door Jumper
#10-32 Thread
Forming
Grounding Bracket w/ESD Port
(4) Bonding Nuts
(2) Bonding Studs #10-32 Hex
#10
Bonding Studs
w/Nuts
Bonding
Nuts
Attach Building Ground
to Bonding Studs

INSTRUCTIONS CM378
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
[email protected]
Fax:
[phone]
www.panduit.com
Page 2 of 2
2.1. Align following components over located hole as shown in enclosure door: (1) #12 External Tooth Lockwasher,
(1) Grounding Bracket, and (1) #10 Split Lock Washer. Fasten with (1) #10-32 Thread Forming Screw. See
Figure 2.1.
Installation: Bracket
Figure 2.1
#10-32 Thread Forming
Screw
#10 Split Lock Washer
#12 External Tooth
Grounding Bracket
Enclosure Door
Installation: Door and Equipment Jumpers
3.1. Install 90-degree lug of door jumper to grounding bracket and secure with (1) #12-24 screw. See Figure 3.1.
3.2. Install flat end of door jumper to one of the bonding studs and secure with (1) #10-32 nut. See Figure 3.2.
3.3 Install 1-hole lugs of (2) equipment jumpers to grounding bracket and secure with (2) #12-24 screws. See Figure 3.3.
3.4 Install 2-hole lugs of equipment jumpers to (2) switches and fasten with provided screws. See Figure 3.4.
Figure 3.2
Figure 3.3 Figure 3.4
Figure 3.1