Paradox MG5050 User manual

Programming steps to the PARADOX MG5050 Control panel
working in conjunction to RDC transmitters.
Connecting the transmitter to the panel:
Connect the R (RING) wire to the transmitter negative. Connect the T (TIP) wire to the transmitter CID
connection. Power the transmitter directly from the battery.
Entering programming:
Press ENTER 0 0 0 0 (This is the default code)
Programming the communicator:
The keypad expects a 3-digit section number
Press 800 Programming of the communicator options
Ensure 1, 2, 5, 6 is on
1 is TLM trouble
2 is TLM reporting
5 is Tone dial
6 is force dial
Press 801 Program reporting options
Ensure 1 is off and 2 is on
1 –off - Always report disarming
2 –on - Zone restoral reports on zone closure
Press 802 Program reporting options
Ensure 1 and 5 is on
1 –on –Report Arm/disarm on MSTN 1
5 –on –Report Alarms/restores on MSTN 1
Press 803 Program reporting options
Ensure 1 is on
1 –on –Report Tamper/restores on MSTN 1
Press 804 Program reporting options
Ensure 1 is on
1 –on –Special reporting on MSTN 1
Press 838 Closing delay to be 000 seconds
Press 851 Armed report delay (default is 5min)
Set it to 001 for 1min

Press 852 Disarmed report delay (default is 5min)
Set it to 001 for 1min
Press 810 Program the communicator format for Contact ID
Press 44
Press 811 Programming of the dialler account number on partition 1
Press 1234
Press 812 Programming of the dialler account number on partition 2
Press 1234
Press 815 Programming of the dialler telephone number 1
Press 1234
Programming zone arming and disarming:
(Note that Zone 4 and 5 has been used as an example)
AWAY arming
Connect relay 1 to zone 5 with the resistor in series on NC and COM
Enter Section 005 for zone 5
Press 26 for the zone type as Momentary Key switch
Press 1 for the partition assignment
None of the zone options should be selected, and press ENTER
Enter Section 745 for Exit delay on Partition 1
Press 000 so that the panel can instantly arm when key switch is activated
STAY Arming
Connect relay 2 to zone 4 with the resistor in series on NC and COM
Enter Section 004 for zone 4
Press 26 for the zone type as Momentary Key switch
Press 1 for the partition assignment
No. 6 of the zone options should be selected, and press ENTER
Enter Section 745 for Exit delay on Partition 1
Press 000 so that the panel can instantly arm when key switch is activated
Press Clear to exit programming

DEOL Wiring
SEOL Wiring