PB TEEN EM-MIX/MATCH PINBRDS S3 GREY User manual

EM-MIX/MATCH PINBRDS S3 GREY
Mounting Instructions
Note: For safe mounting, it is important to use the proper hardware for your wall type (drywall, concrete, etc.).
Contact your local hardware store for assistance if necessary. For safety and ease of mounting, installation is
recommended using two people.
Tools required for installation: Hardware Included:
Phillips screwdriver (6) Metal Screw
Pencil (6) Snap Screw
Wood Stud Mounting:
1) Mark the location on the wall.
2) Using a Phillips-head screwdriver, drive the screws into the wall at the location. The screws should
not be flush to the wall. Leave a gap of about 1/8” between the head of screw and the wall.
3) Hang the EM-MIX/MATCH PINBRDS S3 GREYon the screw heads. If it does not fit properly, you
may need to adjust the gap between the head of screw and the wall and hang again.
Dry Wall Mounting:
1) Mark the location on the wall.
2) Using a Phillips-head screwdriver, drive the dry wall anchors directly into the wall at the location. Do
not force the dry wall anchors as they are designed to bore a hole into the wall without much pressure.
3) Using a Phillips-head screwdriver, drive the screws into the dry wall anchors. The screws should not
be flush to the wall. Leave a gap of 1/8” between the head of screw and the wall.
4) Hang the EM-MIX/MATCH PINBRDS S3 GREYon the screw heads. If it does not fit properly, you may
need to adjust the gap between the head of screw and the wall, and hang again.

Back View
Front view
Care and Instructions:
•Wipe with soft, dry cloth.
•To protect the finish, do not apply household cleaners or abrasives.
Thank you for your purchase
Stores / Catalog / www.pbteen.com