PDQ MRS pdqSMART User manual

MRS pdqSMART INSTALLATION INSTRUCTION
MORTISE LOCK
ALL MRS – EXCLUDING STS Phone: [phone] | www.pdqlocks.com
1. CHECK HANDING OF LOCK BODY
 If handing of lock body is not correct for opening,
consult factory for handing instruction.
3. INSTALL READER AND
INSIDE MOUNTING PLATE
 Install reader assembly and inside
mounting plate – feed reader wire through
hole in door and through slot under circuit
board.
 Feed chassis wire through T slot in
mounting plate.
 Secure with (3) M5 x 50 pan head screws
(thru bolts).
 Make both wire connections after reader
is secure. Push extra wire into door
cavity.
2. INSTALL CHASSIS, TRIM,
TURNPIECE & CYLINDER
 Prepare door according to included
template.
 Install mortise chassis while feeding
chassis wire into hole on inside of door.
 Gently pull wire through hole as chassis
is inserted.
 Install trim using included instruction.
READER
WIRE SLOT
READER
SOCKET
88322 Rev2 – 5/22/20
LH/LHR RH/RHR
CHASSIS WIRE
TURNPIECE
OPTIONAL /
FUNCTION
DEPENDENT
CHASSIS
WIRE
READER
WIRE
INSIDE
MOUNTING
PLATE
READER
ASSEMBLY
CHASSIS
WIRE
SOCKET

MRS pdqSMART INSTALLATION INSTRUCTION
MORTISE LOCK
ALL MRS – EXCLUDING STS
88322 Rev2 – 5/22/20
5. INSTALL BATTERIES AND
BATTERY COVER
 Install batteries and battery cover with
(2) #8-32 x 1" pan head screws.
BATTERY
COVER
4. INSTALL BATTERY PACK
 Plug in battery wire to control board.
 Install battery pack over two studs on
mounting plate.
 Snap battery pack onto retainers on
mounting plate.
BATTERY
PLUG
BATTERY
RETAINERS
BATTERY
PACK