Pentair Everpure 2JT User manual

PRODUCT BULLETIN
PRODUCT BULLETIN
GENERAL PROGRAM PRODUCT TECHNICAL TRAINING
Date: May 26, 2020
Subject: Sanitizing with Pentair Everpure Products
Pentair would like to provide you with information regarding sanitizing your system using products
such as Pentiar® Everpure® 2JT, 4JT or BW2 JT Cartridges.
IMPORTANT! When a system is shut down for an extended period of time, there is potential for
microbiological growth from stagnant water supplies to all foodservice equipment. An Everpure brand
ushing cartridge can simplify sanitization. The following products are recommended to sanitize
Everpure water treatment systems.
EV3108-76
QC Head Plug
EV9608-00
4JT Flushing/Sanitizing Cartridge
EV9608-10
2JT Flushing/Sanitizing Cartridge
EV6001-13
BW JT Flushing/Sanitizing Cartridge
EV3093-96
BW Head Plug
Steps for Sanitizing Your Water Filter System with the Pentair Everpure JT Sanitizing Cartridge:
1. Turn off inlet water supply on the water lter system; remove and discard existing Everpure lter
cartridge. The JT cartridge has a central plug with the long tube attached. The entire assembly will
come out completely, leaving an opening as wide as your thumb.
2. Grasp the tip of the center plug on the
JT cartridge (center top of the cartridge)
and pull out gently.

GENERAL PROGRAM PRODUCT TECHNICAL TRAINING
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
© 2020 Pentair. All rights reserved. EV7017-83 MY20
TECHNICAL BULLETIN
3. Sanitize per the manufacturer’s specication by adding a food-grade sanitizer into the
empty JT ushing cartridge then reinsert the center plug through the hole in the top.
into the empty JT ushing cartridge, then reinsert the center plug through the hole in
the top.
4. Lubricate the O-ring with a high-quality food-grade silicone lubricant; replace the
central plug assembly.
5. Insert the JT can into the lter head, plugging any unused heads in the system, and
slowly open the shut-off valve at the front (inlet) of the lter system. Allow the water to
run to drain until the smell of sanitizer is strong.
6. Then, immediately shut off the water and wait 30 minutes. Do not use the processed
water tap for at least 30 minutes.
7. After 30 minutes, run the water to drain for ve (5) minutes to purge the system of any
residual sanitizer and air in the cartridge.
8. Remove the JT cartridge and, if used, plugs.
9. Replace the JT cartridge with a new Everpure lter cartridge.
WARNING: For RO Systems, never use a JT sanitizing cartridge without removing the RO
membrane cartridge rst. The RO membrane cartridge is chlorine-sensitive and will be
damaged if exposed to chlorine-based sanitizers. Flush the system with at least ve (5)
gallons of water to remove any residual sanitizing chemicals following sanitization.
Contact Pentair Technical Support for assistance at 800-942-1153 and press 1 for direct
assistance with lter ushing, sanitization and cartridge change out procedures or by
email at [e-mail].