Performance PLTDTPM2U2EG User manual

ASSEMBLY INSTRUCTIONS
MODEL: PLTDTPM2U2EG
Thank you for purchasing the Desk Mount Power from Performance Office Furnishings.
Before assembly, please remove all parts from the carton and verify that you have correct quantities.
A 1
B 1 set
C 1
D 1 set
E 1 set
F 1 set
Clamp mount installation Cell phone holder installation
Insert one mount &
touch the le edge,
turn the knob
counter-clockwise to
secure the unit.
Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.
ASSEMBLY INSTRUCTIONS
MODEL: PLTDTPM2U2EG
IN THE CARTON:
X X
X X
X X
INSTRUCTIONS:
1 of 2.

ASSEMBLY INSTRUCTIONS
MODEL: PLTDTPM2U2EG
!ATTENTION !
For indoor use only.
Interconnecting more than 4 units together is not recommended. Do not exceed 1440W total, for all connected units.
Do not open or dismantle the power box unit. High voltage inside could result in serious electrical shock.
Do not allow the power box to come in contact with water or other liquids. Turn off the power immediately should any spills occur or if
the power box comes in con-tact with any liquids.
2 of 2.
ATTENTION
●Indoor use only
●Interconnecting more than 4 units together is not recommended.
●Do not exceed 1440W total, for all connected units.
●Do not open or dismantle the power box unit. High voltage inside could result in
serious electrical shock.
●Do not allow the power box to come in contact with water or other liquids. Turn off
the power immediately should any spills occur or if the power box comes in con-
tact with any liquids.
Grommet mount installation Underneath mount installation
Single Unit connection Daisy Chain connection
Insert the bracket into A
Insert the screw into the
slot of the bracket and turn
the knob counter-clockwise
to secure the bracket.
Turn the nut counter-
clockwise unl the metal
plate touches the boom of
the desk surface, and then
ghten the nut.
A
F
Use bracket F to
mount the power
box under the
table.
Install one side
bracket rst.
And then the
other side.
ATTENTION
●Indoor use only
●Interconnecting more than 4 units together is not recommended.
●Do not exceed 1440W total, for all connected units.
●Do not open or dismantle the power box unit. High voltage inside could result in
serious electrical shock.
●Do not allow the power box to come in contact with water or other liquids. Turn off
the power immediately should any spills occur or if the power box comes in con-
tact with any liquids.
Grommet mount installation Underneath mount installation
Single Unit connection
Daisy Chain connection
Insert the bracket into A
Insert the screw into the
slot of the bracket and turn
the knob counter-clockwise
to secure the bracket.
Turn the nut counter-
clockwise unl the metal
plate touches the boom of
the desk surface, and then
ghten the nut.
A
F
Use bracket F to
mount the power
box under the
table.
Install one side
bracket rst.
And then the
other side.