Performance PLTLEG-BEV24 User manual

INSTRUCTIONS: IN THE CARTON:
Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.
ASSEMBLY INSTRUCTIONS
MODEL: PLTLEG-BEV24/PLTLEG-BEV30
1 of 3
Work surfaces are used in many applications. Pre-installed existing metal inserts in
the top are not required. For the Elements series, 20mm wood screws are provided.
Desk:
1. Place work surface upside down on a clean surface
2. Place both legs upside down on work surface with tabs PLTBBB facing each other
3. Slide cross beam over both tabs on leg
4. Attach cross beam to legs using M6 x 12mm (part 9)
5. Attach center legs on the work surface by using wood screws (part 1)
6. Flip table over to correct position
Return (if used):
7. Attach tab to desk crossbeam using M6 x 12mm bolts (part 9)
* Use holes AB for 24” deep Return
* Use holes BC for 30” deep Return
8. Attach crossbeam to return leg using M6 x 12mm bolts (part 9)
9. Slide crossbeam over tab that is attached to desk crossbeam, attach using M6 x
12mm bolts (part 9)
10. Mount the top onto return assembly using wood screws (part 7)
A. Installation with Adjustable Main Desk Beam
PLTCBBEV Not Included
PLTADJMDBxxxx
Not Included
PLTRBB
Not Included

ASSEMBLY INSTRUCTIONS
MODEL: PLTLEG-BEV24/PLTLEG-BEV30
2 of 3
INSTRUCTIONS:
B. Installation with Fixed Main Desk Beam
PLTCBBEV
Not Included
PLTADJMDBxxxx
Not Included

ASSEMBLY INSTRUCTIONS
MODEL: PLTLEG-BEV24/PLTLEG-BEV30
!ATTENTION !
Do not tighten any screws or bolts until the unit is completely assembled.
Ensure all bolts and screws are tightened before using the table, check bolts and screws every 6 months.
If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.
Failure to follow these warnings may result in injury.
3 of 3
4. POSSIBLE ELEMENT SERIES CONFIGURATIONS
When Using 24” Deep Main Top:
1. Always use holes G, H when main desk is 24” deep.
When Using 30” Deep Main Top:
1. Always use holes E, F when main desk is 30” deep.
# Always use holes I, J when main desk is 24” deep.
# Always use holes J, K when main desk is 30” deep.
INSTRUCTIONS:
PLTRBB
PLTRBB
Flat plates
Flat plates
Flat plates
Flat plates