Performance PLTVALEGMOUNT2430 User manual

SOLD SEPARATELY PLTCBBDESKBEAM
Main Desk Beam Parts List
Place the VA metal or wood leg on the top mount plate, and use
bolts (part 3) to lightly tighten the VA leg to the top mount plate.
When everything is in position, then screw in the bolts tightly.
INSTRUCTIONS:
ASSEMBLY INSTRUCTIONS
MODEL: PLTVALEGMOUNT2430
1 of 2.
IN THE CARTON:
Leg Part List
3. Slide the metal cross beam slightly through the opening found at the top
of the leg
4. Fasten the second leg to the top following steps 2 and 3
5. Centre the cross beam so that it is placed evenly through the opening of
both legs
6. Tighten the cross beam to each leg by using two of the set screws with
Allen Key
7. Use wood screw (part 2) to attach the leg to the work surface.
STEP 1
STEP 2
STEP 3
STEP 4
1. Place top upside down on a clean surface
2. PLBE/PLT table tops are used for several applications, and have many
metal inserts. Only two of these inserts are used for the PLTVALEG.
These inserts are the “A1” inserts, as per the PLT instructions.
Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.
**Please Note: When attaching the metal legs to the laminate tops, not all of the provided holes on these metal legs will line
up with the metal inserts on the laminate tops. The provided wood screws may also need to be used**

ASSEMBLY INSTRUCTIONS
MODEL: PLTVALEGMOUNT2430
!ATTENTION !
Do not tighten any screws or bolts until the unit is completely assembled.
Ensure all bolts and screws are tightened before using the table, check bolts and screws every 6 months.
If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.
Failure to follow these warnings may result in injury.
2 of 2.
Return Support (if used)Return Beam (if used) PARTS SOLD
SEPARATELY