Petsafe Happy Ride Specification sheet

WICKER BICYCLE BASKET
Four paws. Two wheels. Endless adventure.
Happy Ride™

What you have
What you need
4
x
4
x
4
x
4
x
2
x
4
x

1
Insert the fleece liner into the bottom of the basket. Pass the metal ring at the
back bottom of the basket through the small hole at the back of the fleece liner.
Attach the safety tether to the metal ring.

2
Stretch the fleece liner over the top edge of the basket. Insert the four
synthetic leather straps through the holes in the basket edge and through the
corresponding holes in the fleece liner.

3
Separate the upper and lower parts of each handlebar mount.

4
Insert each arm of the wire bracket into the groove on the back of each upper
handlebar mount. Rotate each upper mount until the wire stem snaps firmly into
the groove. (You’ll hear a loud snap.)

5
Separate the front plate from the adjustable brace. Position the plate in front
of the wire bracket and the brace behind the wire bracket and reconnect them
with the nut and bolt.

6
Hang the bracket on the handlebars. (Avoid pinching or bending your bicycle’s
brake cables.) Reconnect the upper and lower handlebar mounts. You have an
extra set of long bolts in case the original bolts are too short for your handlebars.

7
Slide the back pocket on the basket down onto the wire bracket. Check the
position and angle of the basket. The curved back portion of the brace should
rest firmly against your bicycle’s frame.