Phanteks GLACIER G30 STRIX 3090 User manual

RTX
INSTALLATION GUIDE V1.1
GLAC IER G30 STRIX 3090/3080
PH-GB3090ASSRX_BK01/CR01
WARNING -
been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your
components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in
the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
PACKAGE CONTENTS For latest version check www.Phanteks.com
We recommend using isopropanol alcohol.
Apply a drop of the Phanteks Thermal
Compound to the center of the GPU chip
STEP 1. REMOVING STOCK COOLER
GLACIER GB3090ASSRX
QTY: 1
GLACIER Stop Fitting
QTY: 2
Thermal Pads
QTY: 3
M2.5x5 Screws/Washers
QTY: 15/15
Thermal Compound
PH-NDC-01
QTY: 1
Phanteks D-RGB Cable
QTY: 1
Unscrew all highlighted screws to remove
the stock cooler, backplate and heatsink.
STEP 2. APPLYING THERMAL PASTE & PADS
the thermal pads on correct position on
the PCB.
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
both sides of the thermal pads.
Take the EVA-Foam from the box to use
as a base for your installation process.
STRIX RTX 3080
STRIX RTX 3090
backplate screws
stock cooler screws
5
6
5
6
5
6
1111111111
44444444444
2
3
1 1
1111111111
44444444444
2
3
1 1
1111111111
44444444444
2
3
1 1
56
１１１
１
１
１
１
１
１
１
１
１
23
4
4
4
4
4
4
4
4
4
4
4
１
１
１
１
１
１
１
１
１
１
23
56
4
4
4
4
4
4
4
4
4
4
4

STEP 3. MOUNT THE WATER BLOCK
STEP 4. SECURE THE WATER BLOCK
Secure the water block with an additional
9 M2.5x5mm screws and washers to the PCB.
Secure the water block with 4 M2.5x5mm
screws and washers to the PCB.
STEP 5. CONNECT D-RGB LIGHTING
Connect the D-RGB cable to the D-RGB strip
in the water block.
STEP 6. INSTALLING FITTINGS
close the remaining ports with the two
included Stop Fittings.
Connect
to
Phanteks Case / Motherboard Cable
Always perform a leak test before providing
power to any system components.
You can connect the D-RGB cable to a
compatible motherboard with the cable
that is included with the motherboard.
Make sure to lay the GPU with the water
If you have the Backplate, please follow
the Backplate manual forthis step.
PCI bracket.
All Phanteks D-RGB products can be
daisy-chained together.
Carefully position the water block onto the
graphics card. Align the mounting holes on
the PCB with the holes on the water block.
4x
4x
9x
9x