Philips SCF355 User manual
SCF355
1
6
General description (Fig. 1)
1 Bottle warmer
2 Light
3 Settings knob
4 Off setting
5 Defrost setting
6 Milk warming setting for contents up to 180ml/6oz
7 Food warming setting
8 Milk warming setting for contents over and including 180ml/6oz
Important
register your appliance at www.philips.com/
welcome.
Read this user manual carefully before you use the
bottle warmer and save it for future reference.
Warning
- Only use the appliance indoors.
- Keep the appliance and its cord out of the reach of
children aged less than 8 years.
-
water or other liquid.
- Do not let the mains cord hang over the edge of a
table or worktop. Excess cord can be stored in the
base of the bottle warmer.
- Keep the mains cord away from hot surfaces.
- Only connect the appliance to an earthed wall
socket.Always make sure that the plug is inserted
into the wall socket properly.
ENGLISH
- Check if the voltage indicated on the bottom of the
appliance corresponds to the local mains voltage
before you connect the appliance.
-
an earthed extension cord with a rating of at least
13 amperes.
-
or the appliance itself is damaged. If the mains cord
- Do not place the appliance on or near a hot gas or
- This appliance can be used by children aged from
8 years and above and persons with reduced
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children unless they are 8 years and above and
supervised.
- Do not preheat the appliance.
- Always place a fully assembled bottle with cap in the
bottle warmer before you add water.
- Make sure you add water before you switch on the
bottle warmer.
ENGLISH 7
- Hot water can cause serious burns. Be careful when
the bottle warmer contains hot water.
- The accessible surfaces of the appliance may
become hot during use.
- Do not move the appliance when it contains hot
water.
- When the food or milk has reached the required
the bottle warmer. If you leave food or milk in the
increases.
- Always check the food temperature before you
feed your child.
Caution
- This appliance is intended to be used in household
type environments.
- Unplug the appliance when it is not in use.
- Let the appliance cool down before you clean it.
- Follow the descaling instructions to avoid
irreparable damage.
- Do not try to open or repair the appliance yourself.
in your country (see www.philips.com/support).
ENGLISH8
Using the bottle warmer
bottles and milk/baby food in containers and other baby food jars.
Note: Philips AVENT breast milk bags cannot be used in this bottle warmer.
Explanation of settings
- Off setting:The bottle warmer is switched off and the light is off.
is lit (Fig. 2).
- Defrost setting: Defrost a bottle/container of milk/baby food to liquid
- Milk warming setting for contents up to 180ml/6oz: Select this setting
when you want to warm a bottle of milk with a content up to
180ml/6oz.
- Food warming setting: Select this setting when you want to warm a
container/jar of baby food.
- Milk warming setting for contents over and including 180ml/6oz:
Select this setting when you want to warm a bottle of milk with a
content over and including 180ml/6oz.
Using the bottle warmer to warm milk
1 Put the mains plug in the wall socket (Fig. 3).
2 Place a bottle in the bottle warmer (Fig. 4).
3 Fill the bottle warmer with drinking water up to the level of the
milk in the bottle. In case of large amounts of milk, the maximum
level of water is approximately 1 cm below the top of the bottle
warmer.An accurate water level ensures correct warming
performance (Fig. 5).
ENGLISH 9
4 Select the desired setting. See the warming reference table at the
end of this chapter to check how long the milk needs to be
warmed in the selected setting (Fig. 6).
Note:The speed of warming milk depends on the amount of the milk
warmed and on its initial temperature, i.e. room temperature (20°C) or fridge
temperature (5°C).
5 The orange light goes on when you select a setting.This indicates
that the bottle warmer is on (Fig. 7).
Note:Whilst warming the milk circulates and heats evenly.
6 Check the warming reference table for the time required to warm
the milk. Remove the bottle from the bottle warmer after the time
indicated in the warming reference table has passed (Fig. 8).
back into the appliance for a maximum of 30 seconds of extra warming.
This will create a slightly warmer result but without overheating.
Caution: If you leave the bottle in the bottle warmer longer than the
time indicated in the settings table, the milk may become overheated.
Note: If you overheat breast milk, valuable nutrients and vitamins may be lost.
7 Always check the temperature before you feed your baby.
Gently shake the bottle or milk storage container and check the
temperature of the milk by sprinkling a few drops on the inside
of your wrist (Fig. 9).
8 Turn the knob back to the ‘off’ position. (Fig. 10)
Caution: If you do not turn the knob back to the ‘off’ position,
the water keeps warming.
ENGLISH10
Using the bottle warmer to warm baby food
1 Follow the same steps as indicated in the previous paragraph.
2 Make sure to stir the baby food during warming as it does not
holding the container/jar while stirring. (Fig. 11)
After warming test the baby food with a spoon to ensure it is not too
bottle warmer and warm the baby food until it has the desired
temperature.
Note: Due to the high variety of baby food consistencies, it is strongly
recommended to continuously stir and check while you are warming the baby
food for an optimal result.
Defrost setting
indication one small and one larger milk volume are included in the table.
Consider the start temperature of your milk around room temperature
for the warming timings as rough guideline.
Note: Due to the high variety of baby food consistencies, it is strongly
recommended to continuously stir and check while you are defrosting the
baby food for an optimal result.
ENGLISH 11
Warming reference table
Start
temperature of
milk
Milk content 20°C 5°C Frozen
60-90ml/2-3oz 3 min 4.5 min 1-1.5 hrs
90-110ml/3-4oz 3 min 5.5 min
125-150ml/4-5oz 3 min 3.5 min
180-210ml/6-7oz 4 min 5.5 min 1.5-2.5 hrs
240-260ml/8-9oz 4.5 min 7 min
290-330ml/10-11oz 5 min 7.5 min
Note:The indicated warming times are based on Philips AVENT Classic and
Natural PP bottle ranges. Be aware that warming timings of Philips AVENT
standard bottles and glass bottles deviate from these indications.
The characteristics of bottles such as material or thickness may also impact
the warming times, therefore it may take less time to warm a larger volume
of milk.
Note:The indicated defrosting times are based on Philips AVENT food
containers.
Note: Due to the high variety of baby food consistencies, it is not possible to
indicate warming timings for baby food.
Note:The food or milk may feel cool to you, but for a newborn baby its
temperature is very pleasant.
ENGLISH12
Cleaning and descaling
Cleaning
1 After each use, unplug the bottle warmer and let it cool
down (Fig. 12).
2 Remove the water from the bottle warmer for hygienic
reasons (Fig. 13).
3 Wipe the outside and inside of the bottle warmer with a moist
cloth (Fig. 14).
Do not use abrasive, anti-bacterial cleaning agents, chemical solvents or
sharp tools to clean the bottle warmer.
Note: If you used the bottle warmer to warm containers with baby food,
make sure that no spilled baby food remains on the bottom of the bottle
warmer.
Descaling
It is recommended to descale the bottle warmer every four weeks to
1 Mix 10 grams of citric acid with 200ml/7oz of cold water and
pour it into the bottle warmer. Switch on the bottle warmer and
select the milk warming setting for contents under 180ml/6oz for
10 minutes. Leave the solution in the bottle warmer until all
limescale has dissolved.You can purchase citric acid (SCF943) at
www.shop.philips.com/service. (Fig. 15)
Note:You can also mix 50ml/1.7oz of white vinegar with 100ml/3.4oz of
cold water to descale the appliance.
2 Unplug the bottle warmer before you empty it (Fig. 12).
3 Empty the bottle warmer and rinse its inside thoroughly. If you still
see traces of scale after rinsing, repeat the descaling
procedure (Fig. 13).
ENGLISH 13
Environment
- Do not throw away the appliance with the normal household waste
environment (Fig. 16).
Guarantee and support
www.philips.com/
support.
ENGLISH14
15
www.philips.com/welcome.
-
-
-
-
-
-
-
-
-
-
-
16
-
-
-
-
-
-
-
-
17
-
-
-
-
-
www.philips.com/support).
18
-
-
-
-
-
1
2
3
4
19
5
6
30
7
8
20
Other manuals for SCF355
22
This manual suits for next models
1
Table of contents
Languages:
Other Philips Bottle Warmer manuals
Philips
Philips SCF355 User manual
Philips
Philips SCF355 User manual
Philips
Philips AVENT SCF358 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips HD4331/01 User manual
Philips
Philips SCF355 User manual
Philips
Philips SCF355 User manual
Philips
Philips SBCSC250/00 User manual
Philips
Philips SCF282/22 User manual
Philips
Philips SCF250/00 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips SCF355 User manual
Philips
Philips SCF355 User manual
Philips
Philips SCF355 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips AVENT SCF358 User manual
Philips
Philips SBCSC215/23 User manual
Philips
Philips AVENT Anti-colic User manual
Philips
Philips SBCSC250 User manual
Philips
Philips AVENT scf356 User manual
