www.philips.com/lighting
5 mm (0.2 in)
0.14 - 0.5 mm2
(26 - 20 AWG)
RS232 ABUS
RS485
ABUS:
12V/460mA
DALI
Relay:
Max 277V for UL,
Max 250V for CE,
3A (resistive)
GPS
(RPSMA
female)
2G/3G
(SMA
female)
USB*
Micro-sim
card
ETH**
Input:
120-277V for UL,
220-240V for CE 2x A: 0-10V,
0-20mA
(Analog input
impedance is 510ohm)
1x D: Connect terminal to
GND for a digital low.
* Provides2x250mA USB 2.0
host ports totally
** support shielded
Ethernet interface
10/100M Automatic
6 mm (0.24 in)
0.82 - 1.5 mm2
(18 - 14 AWG)
5 mm (0.2 in)
0.14 - 0.5 mm2
(26 - 20 AWG)
8~9 mm (0.31~0.35 in)
0.82 - 1.5 mm2
(18 - 14 AWG)
0.40 - 0.44 Nm
0.40 - 0.50 Nm
0.20 - 0.24 Nm
5 mm (0.2 in)
0.14 - 0.5 mm2
(26 - 20 AWG)
0.15 - 0.20 Nm
0.20 - 0.24 Nm
Micro-sd
card
Open
Leakage
current:
1-15mA
Phase
current:
1-100mA
3
NO 1
COM 1
NC 1
COM 2
NO 2
Switch connection
5
At least one GROUND connection needs to be connected to Earth or
screwed GPS or 2G/3G antenna is connected and installed on cabinet
4
© 2018 Signify Holding. All rights reserved. Specications
are subject to change without notice. No representation
or warranty as to the accuracy or completeness of the
information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and
the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. All other trademarks are owned by
Signify Holding or their respective owners.
4422 409 43453 27 December 2018
Hereby, Signify declares that the radio equipment type
LCN7700 is in compliance with Directive 2014/53/EU. The
full text of the EU declaration of conformity is available at
the following internet address: www.philips.com/red
