Philips Day-Brite User manual

Use Flexible Conduit Only
INSTALLATION INSTRUCTIONS
FOR EMERGENCY LIGHTING
Package Contents
Part Description Quantity
Emergency Lighting
Hardware Kit
1
1
Warnings and Cautions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1. Review the diagrams thoroughly before beginning. If you feel you do not have electrical wiring experience, refer to a do-it
yourself wiring handbook or have your fixture installed by a qualified licensed electrician.
2. All electrical connections must be in accordance with local codes, ordinances, and the National Electric Code. If you are
unfamiliar with methods of installing electrical wiring,secure the services of a qualified licensed electrician.
3. Before starting the installation, disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at
the fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
4. Do not use outdoors.
5. Do not mount near gas or electric heaters.
6. Use cautions when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or in eyes, flush
acid with fresh water and contact a physician immediately.
7. Equipment should be mounted in location and at heights where it will not readily be subject to tampering by unauthorized
personnel.
8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe condition.
9. Do not use this equipment for other than intended use.
10. All servicing should be performed by qualified personnel only.
11. Allow battery to charge for 24 hours before first use.
SAVE THESE INSTRUCTIONS
Rev A 11/10 Page 1 of 2
1
2
IMPORTANT SAFEGUARDS

Mounting Instructions
NOTE: First turn off electricity.
1. Remove mounting plate from fixture.
2. Knockout in back of mounting plate and push wires through
the hole.
3. Securely attach mounting plate to J-box.
Transformer Connect to PCB Ass'y
PCB Ass'y
Mounting Plate
Transformer
6. Connect red lead to battery positive terminal.
Red Wire
Battery
7. Snap fixture onto mounting plate and ensure no wires are
pinched. Make sure unit is fully attached.
8. Restore power and press test button. Battery powered bulb
will come on. AC light will turn off
5. Connect transformer to PCB Ass'y.
Pipe(Not provided)
Pipe Connector
Nut
Screw
Wall Mounting
Ceiling Mounting
1. Open top cover and knockout on the top of fixture.
2. Secure the mounting plate to tube with nut.
knockout
Junction Box
(Not provided)
BLACK
WHITE
ORANGE
120VAC
INPUT
277VAC
INPUT
4. ELECTRICAL CONNECTIONS:
Connect white wire lead from fixture to white (neutral) wire supply
feed from circuit. Connect black (120V) or orange (277V)
(depending on supply voltage) wire lead from fixture to black(hot)
wire from supply circuit.Use U.L. Listed wire connectors suitable
for the size, type, and number of conductors. No loose strands or
loose wires should be present. Secure wire connectors with U.L
listed electrical tape
3. Reference 4 - 8 step in wall mounting above for ceiling
mounting.
Rev A 11/10 Page 1 of 2
Philips Day-Brite • 776 South Green Street • Tupelo, MS 38804
662-842-7212 • Fax [phone] • www.daybrite.com