Planet IPX-330 User manual

Internet Telephony PBX System
(30/100/200/500 SIP Users Registrations)
IPX-330/IPX-2100/IPX-2200/IPX-2500
Quick Installation Guide

Table of Contents
1. Internet Telephony PBX System ................................................................... 3
1.1. Package Contents ................................................................................ 3
1.2 Hardware Installation........................................................................... 4
1.2.1 Safety Instructions ..................................................................... 4
1.2.2 Placement.................................................................................. 4
2. IPX-330 ..................................................................................................... 5
2.1 Physical Introduction............................................................................ 5
2.1.1 LEDDenitions .......................................................................... 5
2.1.2 Physical Connection Topology of the IPX-330 ................................ 6
3. IPX-2100 ................................................................................................... 7
3.1 Physical Introduction............................................................................ 7
3.1.1 LEDDenitions .......................................................................... 7
3.1.2 Physical Connection Topology of the IPX-2100 .............................. 8
4. IPX-2200 / IPX-2500................................................................................... 9
4.1 Physical Introduction............................................................................ 9
4.1.1 LEDDenitions .......................................................................... 9
4.1.2 Physical Connection Topology of the IPX-2200 / IPX-2500.............10
5. BasicSystemConguration ........................................................................11
5.1 New System Setup Wizard ..................................................................11
5.2 Web Admin Login ...............................................................................12
5.2.1 Conguring theNetworkSetting .................................................13
5.2.2 Changing IP Address or forgotten Admin Password.......................15
6. FurtherConguration .................................................................................16

3
1. Internet Telephony PBX System
1.1. Package Contents
Thank you for purchasing PLANET Internet Telephony PBX system. This Quick
Installation Guide will introduce how to nish the basic setting of connecting
the web management interface and the Internet. Open the box of the Internet
Telephony PBX system and carefully unpack it.
The box should contain the following items:
Model Package Description
IPX-330
(30 user registers)
Quick Installation Guide x 1
Power Adapter x 1 (12V DC)
RJ45 x 1
IPX-2100
(100 user registers)
Quick Installation Guide x 1
Power Adapter x 1 (12V DC)
RJ45 x 1
Bracket x 2
IPX-2200
(200 user registers)
Quick Installation Guide x 1
Power Cord x 1
RJ45 x 1
Bracket x 2
IPX-2500
(500 user registers)
Note
If any of the above items are damaged or missing, please contact
your dealer immediately.

4
1.2 Hardware Installation
The following are instructions for setting up PLANET Internet Telephony PBX
system. Refer to the illustration and follow the simple steps below to quickly install
your Internet Telephony PBX system.
1.2.1 Safety Instructions
The following are the safety instructions for Internet Telephony PBX system before
installing.
The maximum operating temperature of the Internet Telephony PBX system is
0~40°C,whichallowssufcientaircirculation.
The connections and equipment that supply power to the IP PBX should be
capable of operating safely with the maximum power requirements of the IP
PBX. In the event of a power overload, the supply circuits and supply wiring
should become hazardous.
The power adapter must plug into the right supply voltage. Make sure that the
supplied power voltage is correct and stable. If the input power voltage is over
10% lower than the standard, it may cause the IP PBX to malfunction.
Generally, when installed after the nal conguration, the product must comply
with the applicable safety standards and regulatory requirements of the country
in which it is installed. If necessary, consult for technical support.
1.2.2 Placement
Make sure the device is placed in a safe environment to avoid equipment failure.
DO NOT place anything on top of the device. Excessive weight could damage it.
DO NOT obstruct ventilation slots on each side of the IP PBX or expose it to
direct sunlight or other heat sources. Be sure that there is adequate air ow
around the IP PBX.
PlacetheIPPBXonaatsurfacetoavoidanydamage.

5
2. IPX-330
2.1 Physical Introduction
IPX-330
Internet Telephony PBX System
Ringing
Ready/Act
PWR WAN 1 2 SYSLAN
Front Panel of the IPX-330
USB 2 1 Console LAN WAN Reset
12V DC
FXO
Rear Panel of the IPX-330
2.1.1 LEDDenitions
Front Panel LED Status Description
PWR Steady Green
Off
PBX power ON
PBX power OFF
WAN
Blinking Green
On
Off
Data is transferring
PBX network connection established
Waiting for network connection
LAN
Blinking Green
On
Off
Data is transferring
PBX network connection established
Waiting for network connection
FXO 1~ FXO 2
Steady Red
Blinking
Off
Ready/Standby
Ringing
Module not available
SYS
Blinking Green
On
Off
System is working
System doesn’t boot
System failed

6
2.1.2 Physical Connection Topology of the IPX-330
USB 2 1 Console LAN WAN Reset
12V DC
FXO
Internet
Video Phone IP Phone IP Phone
Switch Router
ATA Mobile
SIP Phone
100BASE-TX UTP
Telephone wire
2 x FXO
PSTN

7
3. IPX-2100
3.1 Physical Introduction
SLOT 1
IPX-2100
Internet Telephony PBX System
Ringing
FXS
Ready/Act
FXO/GSM
ACT
LNK
21 3 4
SLOT 2
21 3 4PWR SYS LANWAN
Front Panel of the IPX-2100
SLOT 2 SLOT 1
WANLANConsoleUSB Reset Power
12V DC
Rear Panel of the IPX-2100
Note
1. Supporting 2 slots, user can buy expansion module like IPX-21FO
(4 x FXO) or IPX-21GS (4 x GSM) for extending port service.
2. If IPX-21GS is used, please disable pin lock function. Otherwise,
dial out or call in will not be available.
3.1.1 LEDDenitions
Front Panel LED Status Description
PWR Steady Green
Off
PBX power ON
PBX power OFF
SYS
Blinking Green
On
Off
System is working
System doesn’t boot
System failed
WAN
Blinking Green
On
Off
Data is transferring
PBX network connection is established
Waiting for network connection
LAN
Blinking Green
On
Off
Data is transferring
PBX network connection is established
Waiting for network connection
Slot 1~Slot 2
FXO / GSM / FXS
Steady Red
Flashing
Off
Ready/Standby (SIM card inserted)
Ringing
Module not available

8
3.1.2 Physical Connection Topology of the IPX-2100
SLOT 2 SLOT 1
WANLANConsoleUSB Reset Power
12V DC
FXO Card Life Line Card
Internet
Video Phone IP Phone IP Phone
Switch
Router
ATA
100BASE-TX UTP
Telephone wire
Mobile
SIP Phone
Singal Line Telephone
PSTN
4 x FXO 2 x FXS + 2 x FXO
Fax

9
4. IPX-2200 / IPX-2500
4.1 Physical Introduction
SLOT 1
IPX-2200
Internet Telephony PBX System
Ringing
FXO/GSM
FXS
21 3 4
SLOT 2
21 3 4PWR SYS LANWAN
Front Panel of the IPX-2200
SLOT 1
IPX-2500
Internet Telephony PBX System
Ringing
FXO/GSM
FXS
21 3 4
SLOT 2
21 3 4PWR SYS LANWAN
Front Panel of the IPX-2500
USB HDMI LAN
SLOT 2 SLOT 1
WAN
100~240V AC
Rear Panel of the IPX-2200 / IPX-2500
Note
1. Supporting 2 slots, user can buy expansion module like IPX-21FO
(4 x FXO) or IPX-21GS (4 x GSM) for extending port service.
2. If IPX-21GS is used, please disable pin lock function. Otherwise,
dial out or call in will not be available.
4.1.1 LEDDenitions
Front Panel LED Status Description
PWR Steady Green
Off
PBX power ON
PBX power OFF
SYS Blinking Green
Off
System is working
System booting or failed
WAN Blinking Green
Off
Data is transferring
No data transmitting
LAN Blinking Green
Off
Data is transferring
No data transmitting
Slot 1~Slot 2
FXO / GSM / FXS
Steady Red
Flashing
Off
Channel loading succeeded
Channel ringing
Channel loading failed

10
4.1.2 Physical Connection Topology of the IPX-2200 / IPX-2500
USB HDMI LAN
SLOT 2 SLOT 1
WAN
100~240V AC
FXO Card
Internet
Video Phone IP Phone IP Phone
Switch
Router
ATA Mobile
SIP Phone
4 x FXO
PSTN
GSM
100BASE-TX UTP 1000BASE-T UTP
Telephone wire
GSM Card