Playcraft Easy Access Stairs 24" 1201-2 User manual

IMPORTANT NOTES: Read First
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
EASY ACCESS STAIRS 24"
INSTALLATION INSTRUCTIONS
Rev C
1/19/2017
1201-2
Page 1 of 4
An appropriate energy absorbing safety surface is required under and around all playground equipment.
the equipment or consult you surfacing supply representative.
Public Playground Safety, Publication #325 at www.CPSC.gov for the surfacing appropriate for the fall height of
surfacing material may vary in thickness and/or compression depths. See free publication - The Handbook for
Loose fill protective surfacing is shown only as an example for the purpose of this assembly instruction. Other
(A) Use liquid thread lock (such as Loctite
®
) with all threaded hardware. Important: Liquid thread lock (prior to
curing) helps to eliminate the common problem of "thread seizure" in stainless steel hardware by serving as a
lubricant during assembly.
(B) Do not pour concrete until the equipment is completely assembled, leveled and plumbed. Concrete must be
allowed to cure completely before using the equipment (at least 72 hours).
(C) Refer to Installation Manual for 09 Collars and 11 Socket Clamps assembly instructions.
(D)
NOTE: R5-1201-2 Configuration
shown. Other configurations will
vary slightly, but will not affect the
assembly.
FIGURE 1
Easy Access Stairs 24"
and 11 Clamps
Figures 1.1
See Footing Detail
See Installation Manual
Sections 09 Collars
Figures 1.2

For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
EASY ACCESS STAIRS 24"
INSTALLATION INSTRUCTIONS
Rev C
1/19/2017
1201-2
Page 2 of 4
Footing Detail
Top View - Footing Layout
Step 1
Refer to Footing Layout and mark footing hole locations.
Dig 2 Ø 12" footing holes. Refer to Footing Detail for
depth and details.
IMPORTANT: For areas with soft soil conditions, larger
footings may be required.
* Footing depth must be adjusted to compensate for the
depth/thickness requirements of selected safety
surfacing. See Section 06.1 of the Installation Manual.
28
14
"
718mm
13
1316
"
351mm
LOOSE FILL SURFACING MATERIAL SHOWN:
9" compressed or 12" uncompressed depth.
Compressed depth shown. (See Note D)
Concrete Footing
Optional Filter Fabric over
Pea Gravel (for drainage)
Blocking, see
Installers Manual
2b Stone, drain rock
Undisturbed Soil
(Finish Grade)
(Top of Soil)
Footing Anchor
39"
991mm *
30"
762mm
12"
305mm
32
14
"
819mm
8
1316
"
224mm

For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
EASY ACCESS STAIRS 24"
INSTALLATION INSTRUCTIONS
Rev C
1/19/2017
1201-2
Page 3 of 4
Step 5
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
Step 6
Plumb and level entire component. Pour concrete
into footing hole(s). Allow at least 72 hours to
cure before using this equipment. (See Note B)
Step 7
Place required protective surfacing under and
around Easy Access Stairs. (See Note D)
Step 2
Place Transfer Rails into footing holes and attach
to collars as shown in figure 1.1 (See Note C)
Step 3
Attach ADA Steps to Transfer Rails as shown
in Figure 1.2. (See Note A)
Step 4
Attach ADA Steps to deck as shown in Figure 2.
(See Note A)
FIGURE 2
3/8" Lock Nut
3/8" x 1" O.D.
Washer 3/8" x 1" O.D.
Washer
3/8" x 1-1/2"
Button Head Bolt
ADA STEPS
TRANSFER
STATION H. RAIL 36
Figure 1.1
3/8" Lock
Nut
3/8" x 1" O.D.
Washer TRANSFER STATION
H. RAIL 36
3/8" x 2-3/4"
Button Head Bolt
ADA STEPS
Figure 1.2

Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
EASY ACCESS STAIRS 24"
INSTALLATION INSTRUCTIONS
Rev C
1/19/2017
1201-2
Page 4 of 4
Easy Access Stairs 24" R5
Part #
DESCRIPTION QTY
CE-4203 ADA Steps 24-26 1
FS-1209-24 Transfer Station H. Rail 36 2
HS-1001-R5 Socket Clamp Set R5 2
9103072-TR Bolt Button Head 3/8" x 1-1/2" 4
9103122-TR Bolt Button Head 3/8" x 2-3/4" 4
9333002 Washer Flat 3/8" x 1" O.D. x .100" thick 12
9413002 Nut Lock 3/8" 8
Easy Access Stairs 24" R3.5
Part #
DESCRIPTION
QTY
CE-4203 ADA Steps 24-26 1
FS-1209-24 Transfer Station H. Rail 36 2
HS-1001-R35 Socket Clamp Set R3.5 2
9103072-TR Bolt Button Head 3/8" x 1-1/2" 4
9103122-TR Bolt Button Head 3/8" x 2-3/4" 4
9333002 Washer Flat 3/8" x 1" O.D. x .100" thick 12
9413002 Nut Lock 3/8" 8
STEPS & DECKS:
Shall be fabricated using punched, formed and
welded 14 gauge sheet steel. Steps and Decks
shall be Play-Tuff ᵀᴹ coated after fabrication.
STEP RAILS:
Shall be fabricated using 1.315" O.D. 12 gauge
steel tubing with welded 1.660" O.D. 11 gauge steel
leg. The Step Rails shall have a multi-stage baked-
on powder coat finish.
SOCKET CLAMPS:
Shall be two-part and precision die-cast from a high
strength aluminum alloy. The Socket Clamps have
a multi-stage baked-on powder coat finish.
HARDWARE:
Shall be stainless steel, zinc/nickel plated or
galvanized as required to resist rust and corrosion.
Parts List Specifications
Periodically tighten all screws, bolts and nuts. A
periodic inspection of all parts is necessary. If a part
is broken or worn, replace immediately. For general
maintenance please refer to our Playground
Maintenance Manual.
Maintenance