PMV Mounts PMVMOUNT1PA User manual

Mount Ceiling plate To Ceiling
1
Fixing Kit
Pre assembled
Note: Ceiling fixings are not supplied. Use the correct fixings
appropriate for the ceiling material and structure.
A: Position Pole Adapter over exsisting 50mm pole
B: Insert all 4 grub screws from the fixing kit to retain the
pole adapter in position.
A
H - Grub Screw
M6 x 8mm x4
F - Spacer x20
G - of each
Struts
Short,
Medium,
Long x2
E -
Washer
M3,
M4,
M5,
M6
x4
x4
x4
x4
C -
Screw
M3 x 25mm
M4 x 25mm
M5 x 25mm
M6 x 25mm
x4
x4
x4
x4
B -
Screw
M3 x 10mm
M4 x 10mm
M5 x 10mm
M6 x 10mm
x4
x4
x4
x4
Pole adapter Projector mount
Button head bolt
M8 - 75mm
Tilt washer
Tilt lock washer
B
pmvmounts.co.uk
ŸRead these instructions carefully before installing your equipment.
ŸInstall the mount in a suitable location using fixings which are appropriate for
the ceiling material and structure. Consult a qualified builder if you’re in any doubt as
to the structural integrity of the ceiling.
ŸDo not attempt to alter or modify any part of the ceiling mount or its attachments.
ŸDo not use if any parts are broken or appear to be damaged.
ŸTighten all bolts and fixings securely. Only use fixings provided with this bracket.
ŸDo not mount your projector close to sources or heat or moisture.
ŸAlways have a minimum of two persons to install the projector on to the mount.
Mounting instructions for 50mm Pole-adapter projector mount
Fits any 50mm diameter ceiling poles.
Maximum projector fixing points up to 630mm x 325mm - Up to 25Kgs
Model No.
PMVMOUNT1PA
Factory No.
Z0874PA
A - Button head screw
M6 x 8mm x4

Attach struts to projector mount
2
Bx4 Cx4 Ex4 Fx4
or ++
Attach projector mount and struts to all threads
3
Note: Use the appropriately sized fixings from the fixing kit.
Use spacers as required, not always necessary.
Alternative fitment...
Ax4 Gx4
+

Continued...
B: Position both tilt and tilt locking washers and insert
large M8 x 75mm bolt.
Note: This is the tilt adjustment mechanism.
Attach projector mount to pole section
4A: Remove both tilt and tilt lock washers and large
M8 x 75mm bolt from bottom of the Pole adapter.
Position the hooks on the projector mount over the
corresponding parts of the lower moulding.

Adjust the projector
5Rotation: Rotate the projector via the projector mount, the retaining bolt within the ceiling mount is torqued to stay tight but allow
manual rotational adjustment.
Tilt: Adjusted via the tilt locking mechanism between the pole section and projector mount. Loosen retaining bolt and
tighten at desired angle.
Yaw: Fine adjusted via the projector mount. Unlock the yaw adjustment with the locking fly nut.
Adjust yaw with thumb wheel, lock position again with locking fly nut.
Locking fly nut
Thumb wheel
Tilt locking mechanism