PMV Mounts PMVTROLLEYPROJ User manual

2.1
2.2
1.1
1.2
1
2
pmvmounts.co.uk Read these instructions carefully before assembling/installing your equipment.
Do not attempt to alter or modify any part of this trolley or its attachments.
Do not use if any parts are broken or appear to be damaged.
Tighten all bolts and fixings securely. Only use fixings provided with this bracket.
Install the equipment in a suitable location.
Do not store or use your trolley close to sources of heat or moisture.
Instructions for Projector Trolley
Model No. PMVTROLLEYPROJ Factory No. PMVTROLLEYPROJ
Designed & Manufactured
in the United Kingdom
Assembly kit checklist
A - M6 x 70mm
C - Nylon washer
B - M6 x 10mm
D - M6 x 8mm
X4
X4
X4
X4
Also requiredAllen key included
Bx4
Ax4
Cx4
Secure projector tray at desired angle and secure by tightening all four fixings.

3.1
4.1
5.2
5.2
4.2
5.1
5.1
3.2
3.3
3.4
3
4 5
Gently lay on floor
Gently stand upright
Loosen handle to adjust height
Re-tighten once desired height is set
Cut cable management cover to desired length using a
safety knife and insert in to rear of each upright.
Dx4