POLTI DDV User manual

HOW TO USE THIS APPLIANCE
•Before starting the treatment, clean - if necessary - the surfaces and fabrics with the most appropriate method
for removing dirt and dust.
•If your appliance is equipped with steam adjustment - as it can also be used as a steam cleaner
- set it to an average level or, in the presence of preset programs, refer to the instruction manual.
•Heating the dispenser: when the appliance is first switched on, dispense “unusable” steam for about 30 seconds
downwards to reach the optimum operating temperature and pressure.
After each pause before treating surfaces or fabrics, dispense for a few seconds in the same way.
WARNING! THIS PROTOCOL DOES NOT REPLACE THE INSTRUCTIONS
AND WARNINGS CONTAINED IN THE USER MANUAL AND ON
THE APPLIANCE: PLEASE READ THEM BEFORE USE.
FREQUENT SANITISING ACTION
Dispense steam with slow and
repeated strokes on the surface at about
10 centimetres per second.
STATIC STEAM DISINFECTION
Deliver steam, perpendicular to
the surface, maintaining a maximum
distance of 10 centimetres (stand spacer)
for 30 consecutive seconds.
The steam will be able to treat an area with
a diameter of approximately 10 cm.
CHOOSE THE OPERATION YOU WANT TO DO:
DYNAMIC STEAM DISINFECTION
Compliance with the
AFNOR NF T72-110 STANDARD1
Deliver steam, perpendicular to
the surface, maintaining a distance of
0.5 centimetres. Make at least one pass at
a speed of 10 centimetres per second.
DDV - STEAM DISINFECTION DEVICE
COMPLIES WITH AFNOR NF T72-110 STANDARD1
PROTOCOL FOR USE

STAND SPACER CONCENTRATOR
ACCESSORY HPMED2
HARD SURFACES
(including glass)
UPHOLSTERY
(cushions, uphol-
stered chairs, arm
chairs, mattresses...)
FABRICS/CLOTHING3
ELECTRICAL
APPLIANCES4
Refer to the table below for the treatment of the different surfaces and fabrics.
Based on the treatment to be carried out, the table indicates:
- Use of the stand spacer open (distance 10 cm) or closed (close distance);
- Use of the concentrator accessory (straight or curved);
- Inserting the HPMed or empty bottle.
DRAINS AND
GRILLES
TOILETS/
INACCESSIBLE
AREAS
After treatment, wait for the rapid and spontaneous drying of surfaces/fabrics.
Drying times depend on the environmental conditions (temperature and humidity), on correct use of the appliance
and on the nature and temperature of the surfaces.
Complete drying with a disposable cloth if necessary.
1Tested for the medical field - bactericidal, sporicidal, fungicidal and virucidal effect, including Coronavirus. For more information and insights on effectiveness tests visit the site poltisanisystem.com
2The use of HPMed is optional, for use without it connect the empty bottle.
3For fabrics that may be particularly sensitive to heat, avoid concentrating the steam on a fixed point and sanitise with repeated passes. Treat waterproof fabrics as hard surfaces.
4For electrical appliances, remove the plug before carrying out any operation and wait for the surfaces to dry perfectly.
HPMED IS A DETERGENT WHICH ELIMINATES ODOURS.
› It is respectful of the environment
› It can be used in the presence of people and animals
› It can be used on surfaces and fabrics without damaging them
ED. 10IIIV
DYNAMIC STEAM
DISINFECTION
STATIC STEAM
DISINFECTION
FREQUENT
SANITISING ACTION
-
✓
✓
-✓
-- ✓
✓
-
-
✓-✓
STRAIGHT USE EMPTY
BOTTLE
-
CURVED USE EMPTY
BOTTLE
-