Potter PAD100-SB User manual

PAD100-SB
Addressable Sounder Base
8830104 - REV B • 12/17 PAGE 1 OF 2
Description
The Addressable Sounder Base 6” (PAD100-SB) is a sounder base that
may be utilized in a variety of applications. The base has a locking
feature for the sensor that may be used or removed in the eld. Once
the head is removed, the sounder is accessible in the bottom of the unit.
The base has an independent sounder module that may be programmed
as a single station, zone or all call sounder. The PAD100-SB passes
through the sound pattern sent to the sounder, therefore it may
reproduce in any pattern the power supply provides.
The panel will support any combination of sensors or modules on
the SLC. The PAD100-SB does not consume an address on the loop
and is fully programmable to operate with any input. Once activated
the sounder will also follow the input from the power source and de-
activate accordingly.
Technical Specications
Working Range for SLC 24 VDC
Working voltage range for
PWR 16 - 33 VDC
Active current for PWR 30 ma
Sound pressure level 75dB/10ft (min.) as per UL464
Installation temperature
range 32°F to 120°F (0°C to 49°C)
Operating relative
humidity range 0% to 93% (Non-condensing)
Start-up time Max. 1 sec.
Maximum number of
devices per zone 127
Color Eggshell White
Dimensions (without
detector)
Height: 0.75 in (19mm)
Diameter: 6.3 in (166 mm)
Features
• Integrated Sounder in base
• 75 dB (UL 464 Listed) sounder output
• Sounder independent of sensor, allows for a single station,
grouped or all-call
• May be mapped to any device connected to the control panel
• Terminals accept 22 to 12 AWG wire sizes
• Supports Class A, Class X and Class B wiring
• Does not require SLC Loop address
DWG • 516- 933-4900 • dwgdistribution.com

8830104 - REV B • 12/17 PAGE 2 OF 2
PAD100-SB
Addressable Sounder Base
Model Description Stock No.
PAD100-SB Addressable Sounder Base 3992729
Ordering Information
Detector Base Mounting
Locking Feature
PAD100-SB should be mounted directly on the electrical box. The
mounting holes are congured for a single gang, double gang, octagon
or 4” square box. See Fig. 1.
Eliminate the Locking Feature
PAD100-SB include a locking feature that prevents removal of the
detector and removal of the base cover without using a tool.
1. To eliminate this feature, break off the locking tab and then install
the detector. See Fig. 2.
Removing of Detector Head from Base
2. To remove the detector from the base once the locking feature has
been activated, insert a small screwdriver into the slot on the base to
push the plastic tab while simultaneously turning the detector head
counter-clockwise. See Fig. 3.
3. To remove the base cover from the lower enclosure once the locking
feature has been activated, insert a small screwdriver into the slot on
the on the base to push the plastic tab while simultaneously turning the
detector head counter-clockwise.
Using the two included
screws, attached the
detector base to detector
bracket.
Mount the detector
bracket to the back box
using the mounting
screws.
Break off tab (gray
area) in image to disable
locking feature.
Insert small screwdriver
into slot to remove
detector from base.
Alignment Features
Fig. 1
Fig. 2
Fig. 3
DWG • 516- 933-4900 • dwgdistribution.com