PotteryBarn QUEEN User manual

Page 1of 3
TOULOUSE BED QUEEN, KING & CALKING
Date : 9-May-16
Rev : -www.potterybarn.com

Page 2of 3
Important Safety Instructions:
•Please read all instructions carefully before assembling.
•For your safety, assembly by two or more adults is strongly recommended.
•Keep instructions for future use.
•Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
•This bed must be used with a box spring foundation
Parts Enclosed Box 1:
•(A) Headboard –1x
F.
G.
H.
Screw 8 x 1 ¼” – 10x
Allen Bolt ¼” x 1”–12x
Allen Bolt ¼” x 1 ½” –5x
I.
J.
K.
Spring Washers –12x
Flat Washers –12x
Allen Key M4 –1x
1. Attach the Side Rails (C) to Headboard (A) and Footboard (B) by attaching the metal bracket on the side rails to
the Headboard (A) and Footboard (B) as shown in fig. 1.
2. Place Spring Washers (I), Flat washers (J) onto the Allen Bolts (G) through the holes on the metal bracket into the
inserts on the headboard and footboard, tighten with the Allen Key (K) as shown in the illustration. 1.
Parts Enclosed Box 2:
•(B) Footboard –1x
•(C) Side Rails –2x
•(D) Leg Supports –5x
•(E) Slats –5x
L
e
g
S
u
p
p
o
r
t
Fig. 1
Illustration. 1
Hardware Enclosed Box.2:
Tool Required:
C
A
B
A
C
B
E
D

Page 3of 3
3. Attach Leg Supports (D) to the Slats (E) by inserting the Allen Bolt (H) through the hole on the slats into the insert
on the leg supports as shown in fig. 2.
4. Lay the Slats (E) in place over the slat support on the side rails and insert the Screws (F) into the holes at the end
of the Slats (E). Tighten with a screwdriver (Not Included) as shown in fig. 3, illustration. 2.
Care Instructions:
•Dust often using a clean, soft, dry and lint-free cloth.
•Blot spills immediately and wipe with a clean, damp, cloth.
•We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
Fig. 3
Fig. 2
Illustration. 2
K
H
E
D
Thank you for your purchase
Stores | catalog | www.potterybarn.com