PotteryBarn METRO DINING SIDE CHAIR User manual


Date:28‐Apr‐14www.potterybarn.com  Page1of3
Rev:  15‐Sep‐15
















METRO DINING SIDE CHAIR









Date:28‐Apr‐14www.potterybarn.com  Page2of3
Rev:  15‐Sep‐15
Important Safety Instructions:
Please read all instructions carefully before assembling.
For your safety, assembly by two or more adults is strongly recommended.
Keep instructions for future use.
Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
Pre-assembly:
Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as
this will avoid damaging parts during assembly. The shipping box provides an ideal work surface.
Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
Use the parts and hardware lists below to identify and separate each of the pieces included.
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
The use of power tools to aid in assembly is not recommended. Power tools can damage hardware and split
wood.
Parts Included:
(A) Chair Back 1x
(B) Chair Seat 1x
(C) Front Leg 2x

Hardware Included:
(D)
Long Bolt
Dia. 5/16”x3-1/2”
(E)
Short Bolt
Dia. 5/16”x1-3/4”
(F)
Nut
Dia. 5/16”
(G)
Spring Washer
Dia. 5/16”
(H)
Flat Washer
Dia. 5/16”x19mm
4x 1x 4x 9x 9x
Tools Required (included):
(I) AllenWrench5mm (J)OpenWrench
C
B
C
A


Date:28‐Apr‐14www.potterybarn.com  Page3of3
Rev:  15‐Sep‐15
Assembly Instruction Steps:
1. Insert Chair Seat (B) into Chair Back (A) with one end lift up and slot into position as shown, insert Short Bolt
(E), Spring Washer (G) and Flat Washer (H) through the middle hole of seat into chair back, tighten by hand at
first, DO NOT tighten up.
2. Insert Long Bolt (D), Spring Washer (G) and Flat Washer (H) through the pre-drilled holes as shown, tighten by
hand at first and then tighten all bolts with Allen Wrench (I).

3. Attach Front Leg (C) to the chair as shown, put Spring Washer (H) and Flat Washer (G) on the thread of front
leg, screw on Nut (F) by hand and then tighten with Open Wrench (J).





















Care Instructions:
Dust often using a clean, soft, dry and lint-free cloth.
Blot spills immediately and wipe with a clean, damp, cloth.
We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Thankyouforyourpurchase
Stores|catalog
F
H G
J
C
C GHF
J
NOTE: Slightly tilt the Open Wrench could
avoid scratch and easy to tighten Nut. 
F
H
G
J
H
B
D
G
H
G
E
I
I
A
One
end
lift
up
B