PotteryBarn Tate Occasional Coffee Table User manual

Page 1of 2
Tate Occasional Coffee Table
Assembly Instructions
•Please read all instructions before beginning assembly.
•For your safety and convenience, assembly by two people is recommended.
•Use the parts and hardware lists to identify and separate each of the components included.
•Save all packing materials until assembly is complete to avoid the accidental discarding of smaller
parts or hardware.
Tools List:
(1) Wrench 3/8"
Parts List:
(1) Table Top - A (4) Leg – B
Hardware List:
(8) Nuts - a (8) Lock Washers - b (8) Flat Washers - c
Assembly Instructions:
1. Pull out two drawers, then carefully turn the table top (A) upside down on soft, scratch-free surface such
as a carpet or rug. (See Fig. 1)
Fig. 1
Drawer

Page 2of 2
2. Attach each leg (B) to the table top (A) using nuts (a), lock washer (b) and flat washer (c) by wrench (d).
Carefully tighten all nuts, but do not over tighten nuts. (See Fig. 2).
3. Turn the assembed table to an upright position, then put all drawers back in position.
4. Adjusting the levelers:
a) Due to an uneven floor the furniture may not sit level due causing it to wobble. If the table wobbles,
determine which corner does not touch the ground correctly. With two people follow these steps.
b) Carefully elevate the item slightly to provide access to the levelers attached to the bottom. (Fig. 3)
c) Turn the levelers until adequate contact will be made with the floor. Gently set down the piece and
check stability.
d) Repeat steps until furniture sits firmly on the ground.
4. Assembly is complete.
Care Instructions:
•Dust with a clean, soft damp cloth and wipe dry immediately
•Avoid the use of chemicals and harsh cleaning agents
thank you for your purchase
stores | catalog | www.potterybarn.com
Fig. 3
a
b
c
A
B
Wrench
Fig. 2