GB/ US
position (ca. 5 cm far) in the direction of the round side of
the battery charger.
Then please take the VARTA EasyPack contained in the
scope of delivery and place this in the pocketcharger
with the contacts to the round side as well as the
EasyPack Battery with the writing upwards.The VARTA
EasyPack Battery can be placed in the intended battery
compartment with a little pressure. (Do not try to force
the battery into the device. In case of difficulties, it is best
if you ask your hearing aid technician for support).
Afterwards slide the cover back again until the VARTA
EasyPack Battery is completely covered and you feel a
slight resistance.
Now select the desired size from the battery compartment
cartridges contained in the scope of delivery for the
recharge able nickel metal hydride hearing aid battery
power one ACC plus (either 13, 312 or 10, recognisable
through the respective colour code on the battery com-
partment cartridge) and place this in the free compart-
ment in the pocketcharger intended for this purpose.
Please observe that the battery compartment adapter is
inserted in the correct direction. The contacts in the free
compartment which is found on the straight sides of the
pocketcharger must be bound with the corresponding
contacts of the battery compartment cartridge, that is the
straight side of the battery compartment cartridge points
to the straight side of the battery charger and the slightly
notched side points to the round side. The battery com-
partment cartridge latches through slightly pressing with
the thumb. Please do not try to force the cartridge. In
cases of doubt, turn to your hearing aid technician and
ask for support.
To charge the VARTA EasyPack supply battery, please
remove the connection cable which is included in the
scope of delivery, pull it out to the desired length (to
wind it up again pull on both ends at the same time! See
fig. 2, last page) and combine the hollow plug with the
plug contact on the power one pocketcharger. The plug
contact is found on the straight side, with a top view of
the pocketcharger. Connect the SB plug on the other
end of the connection cable now with a suitable energy
source. For this you can use the mains plug adapters con-
tained in the scope of delivery through connecting the
SB plug of the connec tion cable with the SB plug con-
tact provided on the mains part. The mains plug itself has
four different plug attachments. Please select the fitting
plug format depending on the country or region in which
you are located and plug the plug attachment to the
mains plug. Then combine the mains part with a plug
