Prem-I-Air EH0152 User manual

EH0152
2 kW Upright Fan Heater
2 Heat settings
Cool air setting
Adjustable thermostat
Safety tip-over cut-out
Built in carrying handle

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.
BEFORE USE
You must inspect the product including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
INSTALLATION.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance


Place the EH0152 on a firm flat surface at least 20cm (8") from a wall.
Ensure that the air inlets (at the back) and the air outlets (on the front) are not
obstructed.
Do not direct the hot air output towards curtains or soft furnishings.
Do not place on soft surfaces.
Do not cover. This symbol shown on the casing of the heater means that the
heater should not be covered.
Do not use outdoors.
Do not use in bathrooms, or in wet or damp locations.
Do not place the mains lead beneath a carpet or rug.
Do not use the heater in locations where paint, petrol or other flammable
liquids are used or stored.
Do no insert any object into the heater through the grilles. This may damage
the heater or result in overheating or electric shock.
For indoor use only
Not suitable for use in boats, caravans or similar locations.
Do not locate the heater immediately below a mains socket outlet.
Do not use this heater in the immediate surroundings of a bath, shower or
swimming pool.

OPERATION
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead is rated at 10
Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket.
Turn the rotary switch to select the required operation:
0 = Off.
Fan symbol = cool air
1 = Low Heat
2 = High Heat
Do not touch the air output grille when the heater is in operation, because it
will be hot and may cause burns.
Unplug the heater from the mains when not in use.
Using the Thermostat
The thermostat can be use to regulate the room temperature.
Turn the switch to the "hot air" position, and rotate the temperature control
fully clockwise.
The heater will then operate at maximum output. When the desired
temperature is reached, rotate the temperature control anticlockwise until a
click is heard. The heater will then switch on and off to keep the room at the
desired temperature. The indicator light will show that this is happening.
Either the "Warm air" or the "hot air" setting can be used.
If the temperature control is rotated fully anticlockwise, it will operate as a
"frost-stat" and switch the heater on if the temperature drops below 4°C,
preventing damage by frost.

Operating costs.
At time of going to press, the average cost of electricity is £0.11 per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill.
At this cost, the EH0152 will cost £0.11 per hour to run on the "low heat "
setting, and £0.22 per hour to run on the "high heat" setting with the
thermostat set to its maximum.
If the thermostat is used to regulate the temperature the operating costs will
be lower, depending on the room temperature.
On the "cool air" setting, the EH0152 will run for 2½ hours for a penny.
Maintenance.
Before cleaning, turn the heater off, and disconnect from the mains supply.
The heater may then be cleaned using a damp cloth with a drop of washing-
up liquid to remove any dust or dirt from the case. Do no use stronger
detergents or solvents as these may damage the plastic.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the terminal labelled "L".
Connect the blue wire to the terminal labelled "N".
No wire should be connected to the terminal labelled with the earth symbol
or "E".
Make sure that the cord-grip is positioned correctly (over the outer sheath of
the cable) and it fully tightened.

Faultfinding.
The EH0152 has a tilt switch which disconnects the power if the heater falls
over. If the heater is not operating, restore it to an upright position.
The EH0152 has an overheat protection switch, which disconnects the power
if the element gets too hot. The usual reason for this is because the air-flow
has been obstructed, or the grilles have been blocked. If the heater ceases to
operate, leave it for 20 minutes to cool down, then check that the grilles are
not being obstructed.
Turn the switch to the "cold air" setting, and reconnect to the mains supply. If
the fan operates, then it is safe to select the "warm air" or "hot air" settings. If
the fan does not operate, or overheat protection switch operates again,
contact an authorised service agent for repair.
PAT TESTING.
When used in a workplace, this product must be safety-tested yearly by a
qualified electrician (PAT Tested) in order to comply with the Electricity at
Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.

Technical specification
Dimensions: 250×230×130 mm
Weight: 1.0 kg
Power supply: 230 V AC
Power consumption: 2000 W
Operating current: 8.7 A

Service Warranty
Prem-i-Air guarantees the product free from defects in materials and
workmanship for a period of one year.
Should this unit be operated under conditions other than those recommended,
at voltages other than the voltage indicated on the unit, or any attempts made
to service or modify the unit , then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This
warranty is in addition to, and does not affect, your statutory rights.
If you have any problems with this product, please call our Help Desk on
[phone].
Prem-i-Air Appliances Ltd.,
Lancots Lane,
Sutton Oak,
St. Helens,
Merseyside.
WA9 3EX
website: www.prem-i-air.com
Disposal and Recycling
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and
disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your
retailer may take the old appliance for disposal.