Prem-I-Air EH0154 User manual

1
2580 Ver. 3 - 09/18
EH0154
2KW 2-POSITION FAN HEATER
This product is only suitable for well-insulated
spaces or occasional use.

2
2580 Ver. 3 - 09/18
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for
future reference. BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately. PRODUCT SAFETY
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
Do not cover. This symbol shown on the casing of the heater
means that the heater should not be covered.
For indoor use only.
Do not use in bathrooms.
Not intended for use in Boats, Caravans or other similar locations.
Do not use in wet or damp locations.
Do not use outdoors
Please allow for a 50cm safe area around the top and sides, for the front grill
please allow an approx. 120cm safe area.
Do not place the mains lead beneath a carpet or rug.
Please ensure the heater is not positioned below a socket outlet.
Do not use the heater in locations where paint, petrol or other flammable liquids
are used or stored.
Never leave the heater unattended when in use.
Please ensure the heater is switched off and unplug when not in use, also
unplug before assembly or disassembling parts.
Do not use with an extension lead as this could cause the product to overheat.
Do not use the heater for other than its intended use.
Do no insert any object into the heater through the grilles. This may damage
the heater or result in overheating or electric shock.

3
2580 Ver. 3 - 09/18
OPERATION
1. Thermostat Knob
2. On/Off
3. Cool Air
4. Low Power
5. High Power
Remove the heater from all packaging and place it in the desired location in
accordance with the guidelines on page 2.
Please ensure that there is a safe area between the heater and furniture, curtains,
etc. 50cm safe area for the top and sides and 120cm safe area from the front grill.
Unwind the Power Cord and plug it into the Power Outlet.
To turn on the heater turn the power knob (2) clockwise to the low power (4) or high
power (5) position.
To set the room temperature first turn the thermostat knob (1) clockwise and then
turn the control knob to high heat (5). Once the desired temperature has been
reached, turn the thermostat knob (1) anti-clockwise until it clicks. The heater will
then hold the room at the desired temperature.
Please note that if the room is very large the product may not be sufficient to reach
the required temperature.
1
2
3
4
5

4
2580 Ver. 3 - 09/18
For the cooling function, turn the control knob to cool (3) and the thermostat anti-
clockwise.
AUTO SAFETY SHUT OFF
The heater has a built-in safety device, which will switch the heater OFF in case of
accidental overheating.
To reset the heater, follow the next steps:
Turn the control setting to the ‘O’ (2) position.
Unplug the heater from the mains and let the heater cool down, approx. 5
–10 minutes.
Once the heater is cool you are now able to plug in and operate as normal
as per the above instructions to the desired heat setting.
Once the desired temperature has been reached, turn the thermostat (1)
anti-clockwise towards the minimal setting until the heater switches off.
The thermostat switch will keep the room temperature at the desired
temperature automatically.
You can also turn the thermostat switch anti-clockwise to the minimum
position or turn the thermostat switch clockwise to the maximum position
to make the temperature lower or higher.
NOTE: The heater does remain hot / warm for some time after the unit has
been switched off, please handle with care.
PAT TESTING
When used in a workplace, this product should be safety-tested yearly by a
qualified electrician (PAT Tested). We recommend that it is PAT tested regularly
when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for
new buildings).

5
2580 Ver. 3 - 09/18
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.19 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill.
At this cost, the EH0154 will cost £0.38 per hour to run with the thermostat set to
its maximum.
If the thermostat is used to regulate the temperature the operating costs will be
lower, depending on the room temperature.
MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do not use stronger detergents or solvents
as these may damage the plastic.
Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or an
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the terminal labelled
"L".
Connect the blue wire to the terminal labelled "N".
Make sure that the cord-grip is positioned correctly
(over the outer sheath of the cable) and is fully
tightened.
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and disposal
is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your retailer may
take the old appliance for disposal.
TECHNICAL SPECIFICATION
Dimensions: 240×240×120 mm
Weight: 1.1 kg
Power supply: 230 V ~
Power consumption Low/High: 1 / 2 kW

6
2580 Ver. 3 - 09/18
ERP SPECIFICATIONS
Model Number
EH0154
Item
Symbol
Value
Unit
Heat Output
Nominal Heat Output
Pnom
2,0
kW
Minimum Heat Output
(Indicitive)
Pmin
1,0
kW
Maximum Continuous
Heat Output
Pmax,c
2,0
kW
Auxiliary electricity Consumption
At nominal heat output
elmax
0,0
kW
At minimum heat
output
elmin
0,0
kW
At standby mode
elSB
N/A
kW
Type of heat input, for electric storage local space heaters only (single select)
manual heat charge control, with integrated thermostat
No
manual heat charge control with room and/or outdoor
temperature feedback
No
electronic heat charge control with room and/or outdoor
temperature feedback
No
fan assisted heat output
No
Type of heat output/room temperature control (single select)
single stage heat output and no room temperature control
No
two or more manual stages, no room temperature control
No
with mechanic thermostat room temperature control
Yes
with electronic room temperature control
No
electronic room temperature control plus day timer
No

7
2580 Ver. 3 - 09/18
electronic room temperature control plus week timer
No
Other control options (multiple selections possible)
room temperature control, with presence detection
No
room temperature control, with open window detection
No
with distance control option
No
with adaptive start control
No
with working time limitation
No
with black bulb sensor
No
Contact Details
Prem-i-Air Appliances Ltd, Lancots Lane, St Helens,
WA9 3EX
SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in materials and workmanship
for a period of two years.
Should this unit be operated under conditions other than those recommended, at
voltages other than the voltage indicated on the unit, or any attempts made to
service or modify the unit, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This warranty
is in addition to, and does not affect, your statutory rights.
If you have any problems with this product, please call our Help Desk on (0845)
459 4816.
Prem-i-Air Appliances Ltd.,
Lancots Lane,
Sutton,
St. Helens,
Merseyside.
WA9 3EX
Website: www.prem-i-air.co.uk