Prem-I-Air EH1710 User manual

1
EH1710
2kW Convector Heater

2
IMPORTANT
INSTALLER AND USERS PLEASE NOTE:
These instructions should be read carefully and left with the user of the product for
future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
PRODUCT SAFETY
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.
Do not use the heater unless the feet are correctlyattached.
Children shall not play with the appliance.
We advise not to use this heater on carpets which have a thickpile.
Please ensure the heater is placed on a firm and levelsurface.
Cleaning and user maintenance shall not be made by children without
supervision.
Do not cover. This symbol shown on the casing of the heater means that the
heater should not be covered.
For indoor use only.
Do not use in bathrooms,
Do not use in wet or damp locations.
Do not place the mains lead beneath a carpet or rug.
Do not position heater immediately below a socketoutlet.
Before using please ensure the intended socket / electrical outlet matches the
recommended rating issued to the heater.
Do not use the heater in locations where paint, petrol or other flammable liquids
are used or stored.
Please ensure heater is switched off and unplugged when not in use
Please do not use an extension lead with this heater as this could cause the
product to overheat.
Do not use the heater for other than its intended use.
Do no insert any object into the heater through the grilles. This may damage the
heater or result in overheating or electric shock.
There must be a minimum 300mm safe area around the sides of the heater and
a 900mm safe area above, clear of obstructions
Do not obstruct the air intakes at the bottom of this heater.

3
ASSEMBLY / INSTALLATION
Attach the feet to the underneath of the heater using the four 10mm
screws. The feet are paced at both ends of the case.
OPERATION
Note: When heaters are turned on for the first time, or when they are turned on after
not being used for a prolonged period of time, it is normal for the heater to emit
some smell or fumes. This will disappear when the heater has been on a short
while. If the smell does not disappear, we advise to switch off the heater and contact
a specialist.
Follow the guidelines and choose a suitable location for the heater.
To set the thermostat:
1. Turn the thermostat dial fully clockwise to the maximum setting.
2. Turn the heater on using the power switches, once on these will illuminate.
For maximum heat setting, both switches should be on.
3. Once the desired room temperature has been reached, turn the thermostat
anti-clockwise until the thermostat “clicks off” and the lights on the switches
are seen to go out. The heater will keep the air temperature in the room at
the set temperature by switching on and off automatically.
Note: the heater does remain hot/warm for some time after the unit has been
switched off, please handle with care.
1
=
Power = 750W
2
=
Power = 1250W
1+2
=
Power = 2000W
3
=
Thermostat
1
2

4
PAT TESTING
When used in a workplace, this product should be safety-tested yearly by a qualified
electrician (PAT tested). We recommend that it is PAT tested regularly when used
in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years, or at every change of occupancy. For office and retail premises,
and buildings such as village halls, the wiring must be inspected at least once every
5 years. It is recommended that all buildings be fitted with smoke alarms (it is
mandatory for new buildings).
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.145 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill. At
this cost, the EH1710 will cost £0.29 per hour to run, with the thermostat set to
maximum. If the thermostat is used to regulate the temperature, the operating costs
will be lower, depending on the room temperature and the size of the room.
MAINTENANCE
Before cleaning, turn the heater off and disconnect from the mains supply. the
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do not use stronger detergents or solvents
as these may damage the case. Using a dry 1” (25mm) paint brush, remove any
dust from the grilles. If the mains lead is damaged, it must be replaced by the
manufacturer or an authorised service centre. If the mains plug needs to be
replaced, proceed as follows:
Connect the brown (live) wire to the terminal “L”
Connect the blue (neutral) wire to the terminal “N”
Connect the yellow and green (earth) wire to the terminal “E”
Ensure the cord grip is positioned correctly (over the outer sheath of the cable) and
is fully tightened.
13A

5
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste. Most local
authorities have specific collection systems for appliances and disposal is free of
charge to the end user. When replacing an existing appliance with a similar new
appliance, your retailer may take the old appliance for disposal.
TECHNICAL SPECIFICATION
Dimensions:
383 x 530 x 198 mm
Weight:
2kg
Power supply:
230V ~
Power consumption:
2kW
SERVICE WARRANTY
Prem-I-Air guarantees the product free from defects in materials and workmanship
for a period of 1 year. Should this unit be operated under conditions other than
those recommended, at voltages other than the voltage indicated on the unit, or
any attempts made to service or modify the unit, then the warranty will be rendered
void. The product you buy may sometimes differ slightly from illustrations. This
warranty is in addition to, and does not affect, your statutory rights. If you have any
problems with this product, please call our help desk on [phone].
Prem-I-Air Appliances Ltd.
Lancots Lane
Sutton
St. Helens
Merseyside
WA9 3EX
www.prem-i-air.co.uk