Prem-I-Air EH1404 User manual

EH1404
1kW Radiant Panel Heater
Adjustable thermostat
Wall mounting or free-standing
Silent operation
Stylish, slim design
Safety overload cut-out
2 year guarantee
Page 1

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
INSTALLATION
For free-standing use: Loosen the two screws in the wall-
mounting bracket, squeeze the top tabs together and
removed the bracket from the back of the heater. It is not
required for free-standing use. Attach each foot to the
underneath of the heater using the four 8mm screws.
To wall-mount: Referring to the diagram opposite, draw two
horizontal lines on the wall 190mm (7½") apart, the lower line
more than 200mm (8") from the floor.
On the both lines, drill holes 130mm (5") from the centre line,
using a 6mm (¼") masonry bit, and insert a wall plug.
Loosen the two screws, squeeze the top tabs together and
removed the bracket from the back of the heater.
Attach the bracket to the wall using the screws provided.
Attach the heater to the backet, at the lower fixing point first.
Push the top of the heater onto the backet which will snap
into place.
Tighten the two screws in the bracket to lock it in place.
Page 2

DRILLING DIMENSIONS FOR WALL MOUNTING
Page 3

PRODUCT SAFETY
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance
• Place the EH1404 on a firm flat surface. Ensure that the air
inlets (at the bottom) and the air outlets (at the top) are not
obstructed.
• Ensure that curtains are at least 900mm (3') from the top of
the heater
• Leave a gap of at least 50mm (2") at the sides of the
heater.
• If used free-standing, do not operate unless the plastic feet
correctly attached.
• Do not place on soft surfaces.
• Do not cover. This symbol shown on the casing of
the heater means that the heater should not be
covered.
• Do not use outdoors.
• Do not locate the heater immediately below a socket outlet.
• Do not use in bathrooms, or in wet or damp locations.
• Do not place the mains lead beneath a carpet or rug.
• Do not use the heater in locations where paint, petrol or
other flammable liquids are used or stored.
• Do no insert any object into the heater through the grilles.
This may damage the heater or result in overheating or
electric shock.
Page 4

OPERATION
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 6 Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket, and at the switch on
the side of the heater.
Do not touch the air output grille when the heater is in
operation, because it will be hot and may cause burns.
Unplug the heater from the mains when not in use.
Select the required operation on the rotary control:
Select the "snowflake" symbol for "frost-stat" operation. In
this mode, the heater will operate only when the temperature
drops below 5°C, to prevent freezing.
Select the "sun" symbol for normal operation. In this mode,
the thermostat can be used to set the room temperature.
Select the "crescent moon" symbol for night-time operation.
This reduces the temperature by 2°C from normal operation,
without having to readjust the thermostat.
USING THE THERMOSTAT
The thermostat can be use to regulate the room temperature.
Turn the heater on, and rotate the temperature control fully
clockwise.
The heater will then operate at maximum output. When the
desired temperature is reached, rotate the temperature
control anticlockwise until a click is heard. The heater will
then switch on and off to keep the room at the desired
temperature.
Page 5

OPERATING COSTS
At time of going to press, the average cost of electricity is
£0.11 per unit (kilowatt-hour). The amount you are being
charged will be shown on your electricity bill.
At this cost, the EH1404 will cost £0.11 per hour to run with
the thermostat set to its maximum.
If the thermostat is used to regulate the temperature the
operating costs will be lower, depending on the room
temperature. MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the
mains supply. The heater may then be cleaned using a damp
cloth with a drop of washing-up liquid to remove any dust or
dirt from the case. Do no use stronger detergents or solvents
as these may damage the plastic.
Using a dry 1" (25mm) paint-brush, remove any dust from the
grilles.
If the mains lead is damaged, it must be replaced by the
manufacturer or and authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
• Connect the brown wire to the
terminal labelled "L".
• Connect the blue wire to the
terminal labelled "N".
• Connect the green/yellow wire
to the terminal labelled with the
earth symbol or "E".
• Make sure that the cord-grip is
positioned correctly (over the
outer sheath of the cable) and it
fully tightened.
Page 6

FAULT-FINDING
The EH1404 has an overheat protection switch, which
disconnects the power if the element gets too hot. The usual
reason for this is because the air-flow has been obstructed,
or the grilles have been blocked. If the heater ceases to
operate, leave it for 20 minutes to cool down, then check that
the grilles are not being obstructed.
Switch back on, and check that the unit is operating normally.
If not, contact an authorised service agent for repair.
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic
household waste.
Most local authorities have specific collection system for
appliances and disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new
appliance your retailer may take the old appliance for
disposal.
TECHNICAL SPECIFICATION
Dimensions (wall mounting): 594×438×120mm
Dimensions (floor standing): 675×490×237mm
Weight: 5.25kg
Power supply: 230V AC
Power consumption: 1000W
Operating current: 4.3A
Page 7

SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in
materials and workmanship for a period of twelve months.
This Elite product is guaranteed for a further twelve months
subject to the enclosed registration card being completed
and returned to the address printed on it, or the registration
form being completed on-line at www.prem-i-air.com
Should this unit be operated under conditions other than
those recommended, at voltages other than the voltage
indicated on the unit, or any attempts made to service or
modify the unit, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from
illustrations. This warranty is in addition to, and does not
affect, your statutory rights.
If you have any problems with this product, please call our
Help Desk on [phone].
Prem-i-Air Appliances Ltd.,
Lancots Lane,
Sutton Oak,
St. Helens,
Merseyside.
WA9 3EX
website: www.prem-i-air.com
Page 8