Pro Breeze PB-H10 User manual

Instruction Manual
Model PB-H10
1500W Mini Oscillating Ceramic Space Heater
IMPORTANT INSTRUCTIONS
- RETAIN FOR FUTURE USE

1500W MINI OSCILLATING
CERAMIC SPACE HEATER
MODEL PB-H10
IMPORTANT INSTRUCTIONS
Thank you for choosing to purchase a product from ProBreeze. Please read the entire
manual carefully prior to first use and keep in a safe place for future reference.
•Read all instructions before using this
heater.
WARNING: Do not cover the heater.
WARNING: To avoid the risk of
electrical shock, fire or injury to
people, always make sure the heater
is unplugged from the electrical outlet
before relocating, servicing, or
cleaning it.
WARNING: To reduce the risk of fire
or electric shock, do not use this
heater with any solid state speed
control devices.
CAUTION: To prevent electric shock,
match wide blade of plug to wide slot,
fully insert.
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic
safety precautions should always be
followed to reduce the risk of fire, electric
shock, and injury to persons, including the
following:
•
•
•
•
•
•
•
•
•
Use this heater only as described in
this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or
injury to persons.
The appliance is not to be used by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction.
Children must be supervised not to
play with the appliance.
Do not leave children alone or
unattended in the area where the
appliance is in use.
Do not use this heater to dry or heat
clothes.
Cleaning and user maintenance shall
not be made by children unless
continuously supervised.
Ensure the heater is not located
immediately below a socket-outlet.
Do not operate the heater with wet
hands.
To avoid a circuit overload when using
this heater, do not operate another
high-wattage appliance on the same
electrical circuit.
1 | English

English | 2
•
•
•
•
•
•
•
•
•
•
Do not kink or wrap the power cord
and plug around the heater, as this
may cause the insulation to weaken
or split, particularly where it enters the
appliance.
Ensure the mains cable is fully
extended before use and arrange it so
that it is not in contact with any part
of the heater.
Ensure that the mains supply
(including voltage, frequency and
power) complies with the rating label
of the heater.
Do not operate the heater with any
safety guards removed.
Always plug the heater directly into a
wall socket. Avoid using extension
leads where possible as they may
overheat and cause a risk of fire.
Do not allow water or other liquids to
run into the interior of the heater, as
this could create a fire and/or
electrical hazard.
This heater is hot when in use. To
avoid burns, do not let bare skin
touch hot surfaces. If provided, use
handles when moving this heater.
Keep combustible materials, such as
furniture, pillows, bedding, papers,
clothes, and curtains at least a 3 Feet
(0.9 m) from the front of the heater
and keep them away from the sides
and rear.
Extreme caution is necessary when
any heater is used by or near children
or invalids and whenever the heater is
left operating and unattended.
Always unplug heater when not in
use.
•
•
•
•
•
•
•
•
•
Do not operate any heater with a
damaged cord or plug or after the
heater malfunctions, has been
dropped or damaged in any manner.
Discard heater or return to authorized
service facility for examination and/or
repair.
Household use only. Do not use
outdoors.
This heater is not intended for use in
bathrooms, laundry areas and similar
indoor locations. Never locate heater
where it may fall into a bathtub or
other water container.
Do not run cord under carpeting. Do
not cover cord with throw rugs,
runners, or similar coverings. Do not
route cord under furniture or
appliances. Arrange cord away from
traffic area and where it will not be
tripped over.
To disconnect heater, turn controls to
off, then remove plug from outlet.
Do not insert or allow foreign objects
to enter any ventilation or exhaust
opening as this may cause an electric
shock or fire, or damage the heater.
To prevent a possible fire, do not
block air intakes or exhaust in any
manner. Do not use on soft surfaces,
like a bed, where openings may
become blocked.
A heater has hot and arcing or
sparking parts inside. Do not use it in
areas where gasoline, paint, or
flammable liquids are used or stored.

•
•
•
•
•
PET OWNERS WARNING
The health of some small pets, including
birds, is extremely sensitive to the fumes
produced during the first-time use of many
heaters. These fumes are not harmful
to humans, but we recommended that you
do not use your heater around birds and
small pets during its initial use until the
manufacturing corrosion (anti-corrosion)
coatings burn off.
SPECIFICATIONS
Product Dimensions:
6.77 x 5.06 x 10.79in
Net Weight: 3.13lb
Rated Voltage and Frequency:
120V~ 60Hz
Wattage: 1500W
Noise Level: 58dB
•
•
•
SAVE THESE INSTRUCTIONS
This appliance has a polarized
plug (one blade is wider than the
other). To reduce the risk of
electrical shock this plug is
intended to fit a polarized outlet
only one way. If the plug does not
fit fully in the outlet, reverse the
plug. If it still does not fit, consult a
qualified electrician. Do not
connect the heater to extension
cords, surge protectors, timers,
direct breakers, or an outlet with
other appliances connected to the
same outlet.
Always plug heaters directly into a
wall outlet/receptacle. Never use
with an extension cord or
relocatable power tap
(outlet/power strip).
Do not operate the appliance if
there are signs of damage to the
appliance, power cord, or any of
the accessories supplied. If the
supply cord is damaged, it must
be replaced by the manufacturer,
its service agent or a similarly
qualified person in order to avoid
a hazard.
CERAMIC SAFETY INSTRUCTIONS
The temperature of this heater, if placed
too close may become intense enough
to burn exposed skin. Use of this
heater is not recommended for persons
with reduced sensitivity to heat or an
inability to react to avoid burns.
3 | English

1
2
3
4
5
6
Note, this heater features an in-built
tip-over switch so be sure to place the unit
on a flat, even surface.
3.
4.
Turn the temperature control dial until
you hear a click - this will turn the
heater on. Continue turning the
temperature dial to your desired
temperature. The temperature control
dial acts as a thermostat. Once the
room has reached the desired
temperature the heater will switch off.
If the room temperature drops below
the desired temperature the heater
will turn on again.
To activate the oscillation function in
your chosen mode turn the
oscillation mode button to the on (I)
position.
3 21 4 5
6
PARTS
OPERATING INSTRUCTIONS
Temperature control dial
Power/fan only mode control dial
Power light
Safety grille
Handle
Oscillation mode button
1.
2.
3.
4.
5.
6.
English | 4
1.
2.
Insert the plug into the power socket.
Turn the power/fan only mode control
dial to the desired mode.
• FAN - Fan only mode.
• LOW - Low power mode (750W).
• HIGH - High power mode (1500W).
SWITCHING ON AND SETTING
TEMPERATURE

1.
2.
3.
4.
1.
2.
3.
4.
SWITCHING OFF CLEANING
Turn the power/fan only control dial to
the OFF position.
Turn the temperature control dial
counterclockwise to the lowest
temperature setting.
Turn the oscillation mode button to the
off (O) position.
Remove the plug from the power
socket.
NOTES
Overheat Protection
When the temperature of the heater is
too high, the thermostat will
automatically switch off the power and
the heater will stop working. This may
occur during improper use or certain
environmental conditions. After the
heater has cooled for 10 to 20 minutes,
the heater can be used normally.
Tip-Over Protection
When the heater is knocked over or
tipped onto its side, the safety switch
will automatically cut off the power.
Power will return to normal when the
unit has been placed upright onto an
even surface.
Unplug from the electricity supply
before cleaning.
Clean the exterior surface of the heater
by wiping it with a soft, damp cloth.
To avoid scratching the surface, do
not use any abrasive detergents or
solvents.
Ensure the heater is completely dry
before operating.
5 | English

CLEANING & STORAGE
•
•
•
•
•
Clean the exterior surface of the
heater by wiping it with a soft, damp
cloth.
Dry the heater with a soft clean
cloth.
Clean the air inlet and outlet grills
regularly with a vacuum cleaner,
using the brush attachment to avoid
any dust build-up.
To store your product out of season,
we recommend using the original or
similar size box.
Do not kink or wrap the power cord
and plug around the appliance, as
this may cause the insulation to
weaken or split, particularly where it
enters the appliance.
Store the heater in a safe, clean and
dry place when not in use.
WARNING: Always turn the heater
OFF, unplug the power cord from the
electrical outlet and allow the
appliance to completely cool down
before handling or cleaning it.
CAUTION: Do not allow water or
other liquids to run into the interior of
the heater, as this could create a fire
and/or electrical hazard.
CAUTION: Do not use any abrasive
cleaners or solvents, as heater
damage will occur.
The packaging of your new heater has a
recycle mark on it. Please dispose of it
as recycled paper. Waste electrical
products should not be disposed of with
general household waste. This is to
prevent the possible harm to the
environment and human well-being.
Contact your local council or
government for information regarding
the collection schemes in your area.
RECYCLING AND DISPOSAL
English | 6

One Retail Group, Ryland House
24a Ryland Road, Kentish Town, London, NW5 3EH, UK
© Copyright 2021