Pro-Elec PEL01358 User manual

1
Solar Wall Security Light - 90 LED
Model: PEL01358
Please read these instructions carefully before use and retain for future reference.
IMPORTANT SAFETY INFORMATION
• Avoid locations of high temperature or humidity.
• The lamp is rated at IP65 for external use.
WHAT’S INCLUDED
• Lamp assembly.
• User manual.
• Pack of screws and wall plugs.
POSITIONING
• The lamp is suitable for mounting on plasterboard, wood or masonry surfaces.
• It should be mounted in a position of maximum sunlight for optimum charge of the
internal battery.
• Before drilling any xing holes, check that there are no hidden obstructions behind
the mounting surface such as pipes or cables.
INSTALLATION
• Offer the lamp to the surface and mark the location of the
xing holes.
• Drill the wall if required, t the wall plugs then attach the
lamp using the screws provided.

2
OPERATION
• Allow at least 8hrs for the battery to fully charge initially.
NOTE: the lamp does not light except in low ambient light levels.
CLEANING & MAINTENANCE
SPECIFICATION
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Solar panel: 5.5V, 1.43W
Battery: 2 x 3.7V 2200 mAh Lithium non-replaceable.
LED: 90 x white SMD.
Colour LED: 6500K, white.
PIR: detection wide-angle lens of 120 degrees, range from 10 to 12m.
Operating modes: 3 modes plus permanently off.
Working time: up to 10 hours.
Dimensions: L305 x W105 x H48mm.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
1. Solar panel.
2. PIR Sensor.
3. LED function display
4. Operation mode button
1
3
4
• Press the button one or more times to set the mode of operation. The
corresponding indicator LED lights. When there is no operation of more than
30 seconds setting mode is cancelled and the indicator LED extinguishes.
Off: the lamp is permanently switched off.
Mode 1: on detection of movement, the lamp illuminates
and remains lit for 15 to 30 seconds after motion detection
ceases at low brightness.
Mode 2: on detection of movement, the lamp illuminates
and remains lit for 15 to 30 seconds after motion detection
ceases at high brightness.
Mode 3: at low ambient light levels the lamp illuminates and
remains lit constantly. No motion detection is used.
2