Pro-Elec PEL01361 User manual

1
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
Safety Information for Installation and Operation
• Avoid excessive force when installing.
• Always install on a surface that can support the weight of the xture.
LANTERN POST LIGHT
Model: PEL01361 and PEL01362

2
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling
of the materials used. Contact your local authority for details of recycling schemes in
your area.
Made in China. PR2 9PP
Man Rev 2.0
SPECIFICATIONS
CLEANING AND MAINTENANCE
• Clean only with a damp cloth with a little liquid detergent. Do not use any
chemicals, abrasives or solvents that may damage the product.
• Turn off or isolate the mains supply.
• Offer the mounting base onto a suitable masonry
slab in the desired position with reference to
the supply wiring and mark the location of the
mounting holes.
• Drill the ground where marked taking care not to
drill through hidden wiring or pipework and t the
screw plugs.
• Connect the mains supply to the terminal block
inside the base as follows:
Positive supply wire (brown or red) to the
terminal marked L.
Connect the neutral supply wire (blue or black)
to the terminal marked N.
• Attach the mounting base to the ground using screws
into the previously drilled and plugged holes.
• Assemble the diffuser by sliding in the glazing sheets.
• Attach the diffuser by engaging the lugs and turn it to
locate securely.
• Fit an appropriate lamp E27 Max 11W (not supplied).
• Attach the capping onto the diffuser by engaging the lugs
and turn it to locate securely.
• Fit the nial onto the capping by turning it until it locks into
place.
• Restore the mains supply.
INSTALLATION
Voltage 220-240V~50Hz
IP rating IP44
Lamp type E27 11W Fluorescent or LED