PROAIM CINEMA Series User manual

1
What’s In The Box
Please inspect the contents of your shipped package to ensure you have received everything that
is listed below.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright
statutes or in wring by the Publisher.
Hard Mount Kit for Stabilizer Arm (P-HMK-01)
Assem b l y M a n u a l
Hard Mount Wrench
Sturdy Clamp
Hard Mount Mitchell Male Plate
38 mm Bush Allen Key (5/16)
3 x screws

2
The Hard Mount adjusts to 42-50 mm
diameter rods with Sturdy Clamp.
Attach your Stabilizer arm in the provided arm
connector and tighten the knobs properly. You
can adjust the tilt movement of your Stabilizer
arm up to 40 degrees with the help of a
wrench.
Put the Mitchell plate on the boom of Hard
Mount, align the holes & ghten Allen bolts
with Allen Key.
To mount it on any Mitchell Base, loosen the
chuck nut and remove it from Mitchell plate.
Hard Mount Setup
Now put it on the Mitchell base plaorm and
secure it with chuck nut.
Aaching Hard Mount with Rod/Scaold Pole
Aaching Hard Mount With Mitchell Mount
If you want to clamp it with a 38mm rod,
then insert 38mm Bush between the Clamp
and aach it with rod and ghten the knob
properly.

3
YOUR PROAIM HARD MOUNT KIT FOR STABILIZER ARM
ALL DRESSED UP AND READY TO GO!
(SHOWN WITH OPTIONAL ACCESSORIES)
Warranty: We oer one year warranty for our products from date of purchase. Within this period of me,
we will repair it without charge for labor or parts. Warranty doesn’t cover transportaon costs nor does it
cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspecon
and evaluaon by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishandling in
transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissasfacon, please Contact us immediately and we promise our ut-
most support and care unl you use our product.
Follow the same process for arm connector.
Attach your Stabilizer arm, in provided arm
connector and tighten the knobs properly.