PureEdge Lighting Fast Jack Power Round & Square 4" FJP-4... User manual

A1: Turn the power to the electrical box off.
2: Connect the white transformer wire to the neutral power
wire with a wire nut.
3: Connect the black transformer wire to the hot power wire
with a wire nut.
4: Place the transformer and transformer wires inside the
electrical box.
Install the Canopy
1
B
5: Connect each Fast Jack assembly wire to one low voltage
transformer wire with a wire nut.
Installation Instructions for Fast Jack Power Round & Square 4" Flat
Canopies
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is dimmable with a standard ELV dimmer.
- The product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches (98
cubic centimeters).
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: [phone]
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-FJP-4RD_03
TRANSFORMER
3
2
4
ELECTRICAL
BOX
55
FAST JACK
ASSEMBLY
FJP-4_-_

C6: Place all wires inside the electrical box.
7: Secure the Fast Jack assembly mounting plate to the
electrical box by tightening the two provided screws.
2
D
8: Place the canopy onto the Fast Jack port assembly against
the electrical box and secure it in place by tightening the
knurled cap to the Fast Jack port. Make sure the knurled
cap is not cross threaded.
7 7
SCREW
MOUNTING
PLATE
ELECTRICAL
BOX
KNURLED
CAP
FAST JACK
PORT CANOPY
8
E
9: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack canopy port.
CAUTION: Risk of Fire: Max load of Fast Jack canopy is
75 watt.
9
FAST JACK
PORT
6
FAST JACK
FIXTURE
CONNECTOR