PureEdge Lighting Piston User manual

Install the Fixture to Monorail Connector
AFAST JACK
HOUSING
1
FAST JACK
HOUSING
CONNECTOR
FAST JACK
FIXTURE
CONNECTOR
2
2
MONORAIL
1: Place the Fast Jack housing onto the Monorail and use
fingers to tighten the Fast Jack housing connector to the Fast
Jack housing. Make sure that the Fast Jack housing
connector is not cross threaded.
2: Use fingers to tighten the Fast Jack fixture connector into the
Fast Jack housing connector.
B
FAST JACK
HOUSING
CONNECTOR
FAST JACK
HOUSING
1
FAST JACK
FIXTURE
CONNECTOR
2
2
MONORAIL 2
CIRCUIT
Installation Instructions for Piston
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
- This product is intended to be used with PureEdge Lighting
Monorail and Fast Jack systems only.
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: [phone]
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-FJ-PST_02
FJ-PST-__
Install the Fixture to Monorail 2 Circuit Connector
1: Place the Fast Jack housing onto the Monorail 2 Circuit and
use finger to tighten the Fast Jack housing connector to the
Fast Jack housing. Make sure that the Fast Jack
housing connector is not cross threaded.
2: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack housing connector.
1

2
C3: To power the fixture from circuit #1, top and bottom
(neutral) rails, tighten the M3 set screw on top of the
housing with the 1.5mm Allen wrench. Make sure this set
screw connection is very tight.
4: To power the fixture from circuit #2, middle and bottom
(neutral) rails, remove the M3 set screw from top of the
housing and tighten it into the side threaded hole with the
1.5mm Allen wrench. Make sure this set screw
connection is very tight.
NOTE: To avoid shorting the system, do not use more than one
set screw to select a circuit on the Monorail 2 Circuit connector.
NOTE: Do not load either circuit over the maximum system
rating.
3
4
CIRCUIT #1 CIRCUIT #2
1
2
N
1
2
N
M3 SET
SCREW
1.5MM ALLEN
WRENCH
Install the Fixture to Fast Jack LED Single or Multiport Canopies
1: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack Canopy connector.
Adjust the Fixture
D
1: Rotate the fixture head to desired angle.
E
NOTE: The Piston contains an integrated LED lamp. Each fixture
consumes 9 watts.
FAST JACK
FIXTURE
CONNECTOR
CANOPY
1
1
HEAD