PureLink WHD030-V2 User manual

FullHD Wireless
HD Set for HDMI
WHD030-V2
Part 1 Package Content and Connectors
Part 2 Quick Installation Description
Rear View of Transmitter
POWER IN
HDMI IN
DC IN
HDMI OUT
Rear View of Receiver
Quick Installation Guide HDMI Cable x 1 User´s Manual
Mini-USB
Power Adapter x2 USB Cable
(for Transmitter) Anchors x2 Screws x2
Hardware Installation
Transmitter Connections:
Connect to PC via HDMI
Receiver Connections:
Connect to HDTV via HDMI
Connect PC to WHD030-V2 TX
(transmitter) by „HDMI IN" port.
Connect the „HDMI OUT" port of the
WHD030-V2 RX (receiver) to the „HDMI
IN" port of the HDTV with an HDMI cable.
Connect the Mini-USB cable to the
Transmitter and then to your PC.
Connect the power adapter to the
receiver.
Receiver (RX) Transmitter (TX)
Laptop
HDTV
Quick Installation Guide

FullHD Wireless HD Set for HDMI
Quick Installation Guide
WHD030-V2
Part 3 Operation
Activate the WHD030-V2 and set up
the link
Plug in the power for TX and RX, the
WHD030-V2 set will etablish the
connection automatically.
When the power of the transmitter is
plugged off for over 10 minutes, the
receiver will enter Standby mode (Power
LED of receiver will turn red).
When the receiver switches to Standby
mode (PowerLED of receiver is red), plug in
the power of transmitter and the
transmitter will establish the connection
automatically.
Please make sure the HDTV or HD-projector
is already switched to the HDMI input
connected to the receiver.
Make sure the display of your PC is set to
be in „Duplicate", „Extend" or „Projector
only" mode for a signal on the external
display.
If the WHD030-V2 works normal, the
POWER LED and SOURCE LED will be solid
blue, and you can press the INFO button
on the transmitter or receiver to check the
status of signal quality and related
information on the OSD. Press INFO key
again to exit OSD.
Computer only Duplicate Extend Projector only
INFO.
HDTV
HDTV
On-Screen-Display
of Receivers
on HDTV