PYI FENDERTEX FX-BST-800 User manual

Quality Marine
Equipment Since 1981
STEP 1
Using a Philips head screwdriver, unscrew the two screws located on the front of the pump’s battery
housing and the two screws located on the back of the pump’s battery housing.
TOOLS NEEDED
• Needle-Nose Pliers
• Screwdriver (Philips Head)
• Soldering Iron
• Solder
STEP 3
Attach the black (negative) lead wire from the
pump to the black (negative) terminal on the
battery. Attach the red (positive) lead wire
from the pump to the red (positive) terminal
on the battery.
STEP 4
Using a pair of needle-nosed pliers, crimp the
wire connectors onto the batteries terminals for
a secure connection. (Take care not to touch both
battery terminals or lead wires at the same time.
This could cause sparking and possible short-
circuiting of the pump)
STEP 2
Remove the battery case from the pump to
expose the wire leads.
* Assembly required.
FX-BST-800
ASSEMBLY INSTRUCTIONS
FRONT BACK

STEP 6
Test the battery connection by turning the pump
switch on. If the pump does not start, conrm
your lead wires are in place and attempt to
charge the battery.
STEP 7
Once you have conrmed the battery is
connected correctly and the pump switch
turns the pump on, place the battery into the
battery case and t the battery and battery
case to the back of the pump. Ensure there
is minimal tension on the lead wires and the
terminal connections before reinserting the
holding screws.
STEP 8
Secure the battery and its case by reinserting the four screws and tightening them down.
FINAL
Your FX-BST-800 ination pump is now
assembled and ready to be charged for future
use. (Review the batteries instruction booklet for
proper charging technique)
STEP 5
For the best results, use solder to fuse the lead
wires and connectors to the battery terminals.
PYI Inc.
12532 Beverly Park Road
Lynnwood, WA 98087
425-355-3669
[email protected]
www.pyiin.com
FRONT BACK
BATTERY LIFE PER CHARGE
The FX-BST-800 oers about 15 minutes
of continuous use, or inates twelve C124
Fendertex fenders on a single charge.
ASSEMBLY VIDEO
Scan the QR code with a mobile
device to watch our assembly
video of the FX-BST-800.