Pyle Pro PDWM2100 User manual

PROFESSIONAL TRANSMITES SYSTEM
WIRELESS MICROPHONE
PROFESSIONAL TRANSMITES SYSTEM
WIRELESS MICROPHONE
WIRELESS MICROPHONE SYSTEM
INSTRUCTION
SYSTEM PARTS
HOW TO INSERT BATTERY
battery cover
slide switch of power source
9V (9F22)
dry cell
Point
¢Turn round the battery cover to open.
¢Put in the battery according to the
direction seal. The battery should be
9V and please make sure the correct
direction.
¢Put the slide switch to "ON" to check
the power source, if the pilot lamp
is bright, the microphone is ready.
According to different situation, the battery
can use about 10 hours.
PDWN-2100 VHF BAND WIRELESS MICROPHONE RECEIVER
RF A AF A VOLUME A RF B AF B VOLUME B
rod antenna
(2 rod antenna should be
stretched to the longest.)
power source (AC110V) plug
RF B lamp (green)
AF A lamp (green)
WIRELESS RECEIVER
PROFESSIONAL TRANSMITES SYSTEM
WIRELESS MICROPHONE
battery room
pilot lamp
slide switch
R
2
3

HOW TO USE THE WIRELESS MIC
ATTENTION
If the mic lamp of the receiver or the pilot lamp of the microphone does not bright, probablly
the direction of battery is not correct, plase make sure again.
If there is any holing when using, put down the volume of the karaoke system (speaker or
amplifier etc). In addition, put the microphone away from the karaoke system, do not make
the microphone face to the speaker.
When getting dirty, please use piece of soft cloth to clean softly. If very serious, dilute
some neutral lotion to wipe. Intensive lotion such as alcohol. thinner ect, may do harm to
this product, please do not use on it.
¢Plug in the power source of the wireless receiver. (power lamp "red")
¢Slide the slide switch of the microphone to ON, and plug in the power sounce.
¢Please regulate the volume of the karaoke system (speaker or amplifier etc.)
Medial of the Receiver
AC adaptor of medial of the receiver
Medial of the Receiver AC Adaptor
slide switch of microphone
pilot lamp
slide switch
Point The using range of microphone is no
longer than 30m from the receiver.
pull up
rod antenna
¢2 rod antenna should be pulled up and
stretch to the longest.
stretch to the
longest
PDWN-2100
RF A AF A VOLUME A RF B AF B VOLUME B
rod antenna
(2 rod antenna should be
stretched to the longest.)
power source (AC110V) plug
RF B lamp (green)
AF A lamp (green)
WIRELESS RECEIVER
R