QualGear QG-PRO-PM-50-B User manual

Version: Sep 2023
1-Year Limited Warranty
Model: QG-PRO-PM-50-B
Projector Mounting Bracket
For 1.5-Inch NPT Threaded Pipes

Please read the entire installation manual before you start installation and assembly.
NOTE
WARNING
2
Parts Checklist
Hardware Package
IMPORTANT: Before starting installation, please ensure all parts in this checklist are included.
If any parts are missing or damaged, please contact [email protected] for replacement parts,
and do not start assembly and installation until you receive all the parts.
Projector Bracket (x1)
A
M6 x 8mm Screw (x1)
B
4mm Allen Key (x1)
C
M3 x 8mm Screws (x4)
M-A
M4 x 10mm Screws (x4)
M-B
M5 x 10mm Screws (x4)
M-C
M6 x 10mm Screws (x4)
M-D
M4 x 25mm Screws (x4)
M-E
M6 x 25mm Screws (x4)
M-F
D3 Washers (x4)
M-G
D4 Washers (x4)
M-H
D5 Washers (x4)
M-I
D6 Washers (x4)
M-J
5mm Spacers (x8)
M-K
Only begin installing your QualGear product once you have read and
understood all the instructions and warnings in this installation manual. If
you have any questions regarding the instructions, please contact QualGear
customer support via email at [email protected].
This product should only be installed by someone of good mechanical
aptitude who has experience with basic building construction and fully
understands these instructions.
This product was designed to be installed and utilized only as specified in
this manual. Improper installation of this product may cause damage or
serious injury. QualGear is not liable for the improper use or installation of
its products.
Ensure that the supporting surface will safely support the combined load
of the equipment and all attached hardware and components.
Always use an assistant or mechanical lifting equipment to lift and position
the equipment safely.
Tighten screws firmly, but do not over-tighten. Over-tightening can
damage the items, greatly reducing their holding power.
All QualGear products are intended for indoor use only, and any outdoor
use voids the limited warranty.
If mounting to wooden studs, make sure that mounting screws are
anchored into the center of the studs. Use of an edge-to-edge stud finder is
highly recommended.
Never exceed the maximum rated weight specified in this manual.
All bolts and screws must be used at the designated points in the
installation instructions to prevent property damage and personal injury.
Do not install near air conditioner vents or where there is excessive dust
or smoke.
When drilling holes in the ceiling, it is very important to take care of
electrical cables, water, or gas pipes in the ceiling.

1
34
Disassemble the Projector Bracket 2Connect the Adapter Bracket to the Extension Column

56
4Connect the Projector Assembly to the Extension Column
3Attach the Adapter Bracket to the Projector
OR

78
5A Adjustments – Pitch 5B Adjustments – Roll

910
5C Adjustments – Swivel 6A Maintenance - Detach the Projector Assembly from the Extension Column

11
Please check that the projector assembly is secure and safe to use regularly. If you have
questions about the instructions, please contact QualGear technical support at
[email protected].
6B Remove the Projector Mounting Screws
OR
12
6C Detach the Projector Bracket from the Projector