RAB Lighting VXLED13DG User manual

VXLED13DG INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THEAPPLICABLE
INSTALLATION CODE BYA PERSON FAMILIAR WITH THE CONSTRUCTIONAND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable
parts inside.
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: [email protected]
CEILING MOUNT
Fixture must be ceiling mounted. Use a recessed or
surface mount junction box (not supplied) or use the
Housing to make electrical connections. Fixture cannot
be mounted upside down in wet locations!
1. Loosen Housing Screws and open Housing.
2. Prepare back of Housing to use by knocking out
necessary mounting holes.
3. Seal all gaps between ceiling and fixture with
weatherproof silicone sealant.
4. Fixture may be wired through back conduit entrance
or side conduit entrance for surface mounting.
5. Connect wires as shown in wiring section.
6. Close Housing. Tighten screws and check Housing
Gasket seal.
7. Seal all holes, plugs and conduit entrances with
weatherproof silicone sealant.
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
Pat. Pending
Housing
Housing
Screws
Housing
Gasket

VXLED13DG INSTALLATION INSTRUCTIONS
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct.
2. Is there voltage at the lamp fixture wires? If there is
no voltage, check all connections.
3. Is the fixture is grounded properly?
VXLED13DG-IN-0211
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool
enough to touch. Do not clean or maintain while
fixture is energized.
1. Clean glass lens & fixture with non-abrasive glass
cleaning solution.
2. Do not open fixture to clean the LED. Do not touch
the LED.
WIRING
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz.
1. Connect the black fixture lead to the (+) LINE
supply lead.
2. Connect the white fixture lead to the (-) COMMON
supply lead.
3. Connect the GROUND wire from fixture to
supply ground.
-*()5
'*9563&
-*/& #-"$,
$0..0/ 8)*5&
(306/% (306/%