-1- -2-
Remove the cabinet base from the
tool chest
Carefully lay the cabinet on its top and
refit base.
BASE AND CASTOR ASSEMBLY
DRAWER REMOVAL
Components
PARTS
NO. DESCRIPTION QUANTITY
Tool chest components
Cabinet components
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
1 PC
2 PCS
8 PCS
18 PCS
1 PC
2 PCS
3 PC
6 PCS
6 PCS
1 PAIR
2 PCS
1 SET
1 PC
4 PCS
8 PCS
1 PACK
1 PC
1 PC
2 PCS
4 PCS
2 PCS
1 SET
LID
SIDE HANDLE
BOLT
FRICTION SLIDE
LARGE DRAWER
MEDIUM DRAWER
PLASTIC DRAWER
PULL (LONGER)
SMALL DRAWER
PLASTIC DRAWER
PULL (SHORTER)
LID SUPPORT
LOCK BAR
LOCK & KEYS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
TUBE HANDLE
BOLT & WASHER
FRICTION SLIDE
CASTOR PACK
PLASTIC HANDLE
LOCK BAR
BIG DRAWER
PLASTIC DRAWER PULL
SMALL DRAWER
LOCK & KEYS
a) Pull the drawer all the way open, then
push it back to align the slide stop with
opening.
b) Push the slide stop in with a screwdriver
as shown until the slide stop clears the
stop on the drawer glide
c) Repeat (b) for the other side and
remove the drawer.
To reinstall drawer
Prise out the slide stop (approx. ¼"), and
slide the drawer channels back onto the
glides.
Firmly push drawer in until it reaches the
closed position.
MAINTENANCE
Drawer slides and castors should be lubricated periodically with general purpose oil.
Check all screws, nuts and bolts periodically for tightness to maintain trouble free operation.
Safety Instructions
When moving the tool cabinet, ensure all drawers are closed for safety reasons.
Lock the castor when in position to stop unwanted movement during use.
Open one drawer at a time to avoid any possibility of tipping.
The tool chest is
stored inside the
cabinet section for
transit purposes.
Unscrew the base
from the cabinet
to remove the tool
chest
Fit the caster brackets to the base of the
cabinet with nuts & bolts supplied. Then
insert castors (Tools not included for
assembly).
